initial temperature的例句大全

TGA analysis showed that the cured product has a initial decomposition temperature and the end of temperature of 329.4 ℃, 417.5 ℃, which demonstrate that this new epoxy resin have good heat resistance.

用热重分析的方法分析了在此条件下固化产物的分解温度和终止温度分别为329.4℃和417.5℃，这表明所合成的新型环氧树脂具有良好的耐热性能。

And the optimum incubation time was 24h, the optimum temperature was 25 ° C, the optimum broth initial pH was 5.5. The optimum carbon source, nitrogen source and irritant factor were defined by single element, then optimized by CCRD.

结果表明，最佳培养条件为25℃恒温厌氧培养24h且培养基初始pH值为5.5；通过单因素确定最佳碳源、氮源、刺激因子后采用三元二次回归正交旋转设计进行优化。

In visible experiment, the time of pressure balance decrease with the initial pressure of PRZ and temperature of CMT.

在可视化实验中随着PRZ初始压力的增加，以及CMT初始温度的增加，压力平衡响应时间减小。

The influences of solution pH, dosage of iron, reaction temperature and time, and the initial concentration of DCAA ( or TCAA) on the degradation were studied.

考察了溶液初始pH值、铁投加量、反应温度、反应时间、初始卤乙酸浓度对降解率的影响。

Regression Analysis of Correlation between Initial Airflow Temperature in Working Section and Operating Parameters of HXD

HXD运行参数与工作段气流初始温度相关性的回归分析

Shape memory alloy wires can increase the critical temperature of the beam, and also can restrain thermal buckling occurring or make the post-buckled beam back to initial equilibrium states.

形状记忆合金丝还能提高梁的热屈曲临界温度，抑制梁热屈曲的发生或使已发生热屈曲的梁回复到原来的平衡状态。

The conversion of benzaldehyde and yield of benzylidene acetone were influenced by reaction time, temperature and initial water volume.

温度、反应时间和初始水量对反应的转化率和苯丁烯酮的产率有不同的影响。

Preliminary Analysis for Scheme Designs of Initial Core of 10MW High Temperature Gas Cooled Test Reactor

10MW高温气冷实验堆初装堆方案设计初步分析

It is suggested that growth temperature of the AlN buffer layer influences GaN morphology by forming different AlN seed size and density on the Si ( 111) substrate during the initial growth of the buffer layer.

进一步解释了GaN外延层表面形貌中凹坑的形成及凹坑与缓冲层生长温度的关系.结果表明，温度的高低通过影响缓冲层初始成核密度和成核尺寸来影响外延层表面形貌。

Since initial adjustment of household heating meter system possess necessary control equipments& self-operated differential pressure controlling valve, temperature control valve and the pump of frequency conversion.

由于分户热计量系统初调节与以往的初调节相比，拥有必要的控制设备&自力式压差控制阀、温控阀、变频水泵。

Analysis of delayed supercritical process with initial power and temperature feedback

考虑初始功率有温度反馈的缓发超临界分析

Delayed Supercritical Process with Temperature Feedback at Arbitary Initial Power

任意初始功率下考虑温度反馈的反应堆缓发超临界过程

The delayed supercritical process of nuclear reactor with temperature feedback and initial power while inserting small step reactivity(ρ_0 < β) is investigated.

对输入小阶跃反应性（ρ0

The calculation indicates that the main parameter effecting laser output power is the peak electron temperature, while the limitation of repetition rates is related to the initial electron density.

通过计算揭示出影响激光输出功率的主要因素是峰值电子温度，而重复频率的限制主要取决于初始电子密度。

Thermogravimetric analysis shows that the regenerated cellulose has lower initial decomposition temperature and maximum weight loss temperature than initial cellulose. It shows poor thermal stability.

热重分析表明，再生后的纤维素的初始裂解温度和达到最大失重速率时的温度都较低，热稳定性较原纤维素稍差。

But compared with PP-IFR, the initial decomposition temperature and maximum decomposition temperature of PP-IFR/ MWNTs-COOH were delayed and carbon content were also decreased.

而PP-IFR/MWNTs-COOH复合材料的初始分解温度和最大热分解温度与PP-IFR比较却延后，成炭量也下降。

The results obtained shown that the initial decomposing temperature and maximum decomposing temperature of PU are postponed and the exothermic rate is retarded with adding the thermal stabilizer.

结果表明由于热稳定剂的加入，使PU的外推起始分解温度和最大分解温度推迟，放热速度减慢。

In order to verify the mathematical model, experiments were carried out on a small-scale caster. Thermocouples column were adopted to measure the temperature of initial solidification area.

同时，为验证数值模拟结果的正确性，文中设计了实验室的小型连铸实验，并以锡为模拟介质，采用热电偶序列对初始凝固区域温度进行测量。

The heat transfer in continuous casting of Tin was calculated with this model, it was found that temperature of initial solidification area was varied periodically along with mold oscillation.

在此基础上，模拟了结晶器振动条件下的锡液初始凝固传热行为，发现锡连铸中，初始凝固区域温度随结晶器振动而发生周期性变化。

Calculation method of initial nucleation temperature of phases during rapid solidification by continuous cooling of multi-step reaction

连续冷却多阶段快速凝固过程起始形核温度的计算