injection condition的例句大全

The state of mercury film on the surface of wall-jet glassy carbon electrode under different pre-plating mercury conditions in flow injection analysis-differential pulse anodic stripping voltammetry has been studied with microscope and microphotograph, and thereby suitable condition for pre-plating mercury was obtained.

通过显微观察，研究了在流动注射一示差脉冲阳极溶出伏安法中，使用壁喷玻碳电极时，在不同的预镀汞膜条件下，在电极表面上形成的汞膜的状态。

design of the injection mould for the upper shell body of the hanging part of the air-conditioner

空调挂机上壳体注射模设计

design of injection mold for the horizontal blower fans of hanging air-conditioner

空调挂机水平风叶注射模设计

Conclusion: injection can improve high agglutination condition.

结论: 血塞通注射液能有效的改善血液高凝状态.

OBJECTIVE : To study the best preparation condition of Metronidazole Injection.

目的: 探讨甲硝唑注射液的最佳制备条件.

Having been modified, water was slowed down corrosion and scale buildup and reduced treatment cost and environmental pollution. Also, water absorbing condition of injection well was improved and waterflooding producing reserves of oil field were increased.

改性处理后的水不仅提高了水质，减缓了腐蚀和结垢，降低了污水处理成本，减少了对环境的污染，而且还改善了注水井的吸水状况，增加了油田水驱动用储量。

The air inflow in each circle is basically constant, while the diesel engine is working. So each working condition is adjusted to change the output power, by means of changing the oil injection ( changing the density of the gas mixture).

柴油发动机工作时每个循环的空气进气量基本上都是恒定的，要改变输出功率，只有通过改变喷油量（即改变混合气的浓度）来调节各个工况。

In this paper, we will mainly discuss the effect of UPC on energy distribution and each smelting index of blast furnace under the condition of a large amount of coal injection with oxygen enriched by blast furnace energy management optimizing and expert prognosis system developed.

通过开发的高炉能量管理优化系统（B·E·M系统），讨论了高炉富氧大喷煤条件下，未燃煤粉对高炉能量分配及各项冶炼指标的影响。

The Study Condition of Intracellular Toxin Tests in Traditional Chinese Injection with KTA

动态浊度法测定中药注射剂细菌内毒素的研究概况

Results The medicine dosage form clinical use exists the improper service condition for the tablet, the gelatine capsule and the injection.

结果药物剂型临床使用存在有片剂、胶囊剂和注射剂的不当使用情况。

In the ideal condition, injection to production ratio turns out to become 1 as the time of waterflood lasts.

在理想情况下注采比的变化趋势是随注水时间的延续趋近1。

It is a economical and reasonable way to use short, fast, hot water injection in order to change the condition that temperature log can't delineate water injection profile.

在注水方案中，短期、快速、热注是改变当前温度测井曲线对注水剖面反映不明显或不能反映注水情况的一个比较经济合理的方法。

The start test, fuel switch control test and idle condition emission test are carried out on the LPG engine test bench, and a preliminary control performance assessment for the marine LPG engine injection control system are made.

在LPG发动机试验台上，开展起动、燃料转换控制和怠速工况排放试验，初步考核了船用LPG发动机喷射控制系统的性能。