injection pressure的例句大全

The effects of different insulation, tank pressure and injection situations on the precooling process were investigated.

研究了输送管壁不同绝热条件、贮箱增压及气体引射对自然循环预冷过程的影响。

study of calculation model of pressure field of water injection string

注水管柱压力场计算模型研究

wigner-ville distribution was used to study the time-frequency characteristics of pressure wave in fuel injection system of a four-stroke diesel engine under condition of liquid-gas tow-phase flow.

利用Wigner-Ville分布算法对液-汽两相流状态下的四冲程柴油机喷油系统中的压力波的时频特性进行了研究。

influence of wellhead back pressure and gas injection rate on bottomhole pressure

井口回压和注气量对井底压力的影响

the maximum pressure drop for ball depressurization injection allocator is 2.4 mpa, and viscosity loss is less than 10%. the viscosity reduction ratio is rectifiable, and the peak value is 79% for viscosity-breaking injection allocator using electrochemistry catalytic viscosity reducing method.

投球式降压配注器最大压降达到2.4MPa，黏度损失小于10%，降黏配注器采用电化学催化降黏方式，最大降黏率79%，并且降黏率可以调整。

high pressure fuel injection pump assembly

高压喷油泵总成

force analysis of high pressure water injection string

高压注水管柱受力分析

this principle is to use the ink-jet printing piezo actuator device to be fixed in ink spray nozzle pressure continuous injection.

这栽喷墨打印道理是诳骗压电驱动安设差喷脚洋墨水加以变动不张力，使其不断喷射。

application of high pressure rotary mortar injection method in foundation treatment of high building

高压旋喷注浆法在高层建筑地基处理工程中的应用

calculation methods for temperature and pressure distribution in supercritical gas injection well

注超临界气体井筒温度压力场计算方法

application of dynamic pressure water injection technology for coal winning face or heading face in daping mine

采掘工作面浅孔动压注水技术在大平矿的应用

isuzu developed new high pressure fuel injection system to install on brand new direct injection light duty diesel engine, 4jx1tc for suv.

介绍了五十铃公司新开发的多功能休闲车（SUV）用4JX1TC柴油机高压燃油喷射系统。

this paper focuses on the direct injection gasoline during the compression stroke and expansion stroke, analyzes the change process of pressure, temperature and flow field during the fuel injection period, before and after fuel injection.

本文主要对直喷式汽油机在压缩冲程和膨胀冲程中的燃烧进行模拟，分析了喷油前、喷油中、喷油后压力、温度及流场的整个变化过程。

determination of reasonable water injection rate by using capillary pressure curve

用毛管压力曲线确定合理注水强度

through the tests it is found that with regard to tube-outside jets the variation of injection pipe bubbling layer height and pressure drop at a bottom seal in three kinds of test tubes is very stable.

试验发现，对管外喷射，三种试验管型中底端封口的喷射管鼓泡层高度和压力降的变化都非常稳定；

based on displacement test, study the influence of injection way, pressure, permeability and original oil saturation on displacement efficiency, and reveal displacement mechanism.

本文利用细管实验测定了CO2与原油的最小混相压力，通过室内驱替实验，研究了注入方式、压力、渗透率、初始含油饱和度等对驱油效率的影响，揭示了CO2-原油的驱油机理。

methods: sixty-eight patients with hypertensive emergency were randomly divided into two groups, blood pressure and heart rate were observed 0.5,1,3,6,9,12,18 and 24 hours after intravenous sodium nitroprusside or urapidil hydrochloride injection respectively.

方法：高血压急症68例随机分为两组，分别应用硝普钠和乌拉地尔治疗，并观察每组患者治疗后0.5、1、3、6、9、12、18及24h血压及心率的变化。

numerical simulation on effect of pressure relief of water injection well on casing squeeze pressure

注水井泄压对套管挤压力影响的数值模拟

assessment of capacity of bearing pressure of steam injection pipeline and verification of full-scale test

注汽管道承压能力评估和实物试验验证

the fuel injection timing is delayed as the fuel pressure increases until the optimum fuel injection timing is reached.

随着燃料压力的增加，燃料喷射定时被延迟，直到达到最佳的燃料喷射定时。