inlet的例句大全

The relationships between inlet pressure distortion or combined pressure and temperature distortions and the surge margin losses are obtained.

对三级实验压气机进行数值分析后，给出了压气机进口稳态压力、压力-温度联合畸变与压气机稳定裕度损失之间的定量关系；

With the increase of friction coefficient, the area of high temperature zone and the stress at the inlet of the corner increased;

随着摩擦系数增大，核心高温区面积增大，转角入口区的应力也有所增加；

Drawback of vertical tubular air preheater is the greater corrosion of tubes at the low temperature zone due to cold air inlet.

立式管式空气预热器的缺点，是冷风进口处的管束低温腐蚀严重。

The inlet film thickness was defined by analyzing the inlet zone, and the influence of unsteady variables such as strip tension stress, rolling speed and inlet angle on inlet film thickness was considered.

考虑了非稳态变量如带张力、轧制速度、入口角等因素对入口油膜厚度的影响，同时还分析了入口油膜厚度的频率响应情形。

The experimental device on the performance of vortex tube is designed, and its cooling performance affected by inlet pressure p0 and cooling air ratio μ is investigated.

针对进气压力p0、冷气流率μ对其冷却性能的影响进行了试验研究。

He simultaneous data acquisition system with multi-channel and large-capacity is the important equipment in the flow-field match test of aircraft inlet/ engine and vibration mode test of aircraft, ships and automobiles.

多通道、大容量同步数据采集系统，是飞机进气道／发动机流场匹配试验，飞机、舰船和汽车的振动模态试验中的重要测试设备。

Units at inlet and exhaust pressure adjusting system on altitude simulation test cell includes the engine intake pressure adjusting system, exhaust pressure adjusting system.

高空台进排气调压系统包括：发动机进气压力调节系统，排气环境压力调节系统。

Automatic Test System of Control Channel of Compressor Inlet Guide Vanes Based on VI

基于VI的压气机静子调节通道自动测试系统

Development of a Portable Test Set for inlet Control System

便携式进气道斜板控制系统检测仪的研制

In the paper, Inlet pressure effects on the thermohydrodynamic performance of a thrust bearing are investigated theoretically.

从理论上研究了进口压力对推力轴承热动力润滑性能的影响。

Therefore, the inlet pressure is very important in the analysis of the thermohydrodynamic performance of high speed light load thrust bearings.

因此，进口压力是分析研究高速轻载可倾瓦推力轴承热动力轴承热动力润滑性能中的一个不可忽略的重要因素。

Based on the designed thin film evaporator, the influence of the rotor speed, feed rate and liquid inlet temperature on evaporation length and film heat transfer coefficient was primarily discussed using the software CFX 4.4 with water as feed liquid.

针对自行设计的薄膜蒸发器，以水为物料，采用大型CFD软件CFX4.4，初步探讨了刮板转速、进料量、进料温度等参量对薄膜蒸发器蒸发段长度和加热段膜内传热系数的影响。

Effect of Inlet Velocity Distribution on the Flow and Performance of Subsonic Two-Dimensional Diffuser

进口速度分布对二元亚音速扩压器的流动和性能的影响

Two-dimensional subsonic diffuser flow with uniform shear velocity profile at inlet

进口为均匀剪切流的二元亚音扩压器

If inlet end adopt socket weld and outlet end adopts threaded connection, use "U" to express connection unit "S".

如进口端采用承插焊，出口端采用螺纹，则连接单元“S”用“U”表示。

Based on the dynamic static pressure variations, a new criterion and a recognition method of aerodynamic stability in multistage compressors with inlet dynamic distortions are developed. The predictions for a three-stage axial compressor with dynamic temperature, dynamic pressure and their combined distortions are given.

应用新准则分别对进口动态温度、动态压力及动态动力&温度组合畸变下的多级轴流压缩系统的气动稳定性进行了预测分析。

Experimental research was carried on a three-stage low-speed axial compressor with different inlet distortion.

本文对一台带有不同周向进口畸变装置的三级、低速、轴流压气机进行实验研究。

In short, we have just one oncoming point ( house) for the inlet of Karma and it is distributed and utilized in three-way system ( 3 houses) during the lifetime of that individual.

简而言之，对个人的整个人生来说，我们只有一个点（宫）作为业力的入口，而它被分配及利用于3个系统（宫）中。

When the relative humidity of gas at the inlet is increase, the threshold current density is linearly decreased;

临界电流随阴极气体进口相对湿度的增加而线性下降；

The results of numerical and experimental studies of a new configuration of 3D hypersonic inlet with the minimum throat area, which was called a convergent inlet, are presented in this paper.

介绍一种新型的、具有最小喉道面积的三维高超声速进气道（称之为收敛形进气道）的数值和实验研究结果。