interface controller的例句大全

Abstract This paper introduces the ion pump controller which consist of MC-51 single chip processor and it's interface circuits. It includes ion pump property, major technical function, software and hardware's design and measures taken for the safty of system.

本文介绍了用MC－51单片机及其外国电路组成离子泵智能控制器的特点，主要技术性能，设计指导思想，系统的软硬件设计及对整机可靠性所采取的技术措施等。

After that a master DAMA controller and three slave DAMA controller and subscriber interface equipments have been accomplished.

在此基础上完成了一个主DAMA控制器和三个分站DAMA控制器及用户接口设备的研制。

The hardware of the system consists of an industrial control computer with motion controller and PCL-818L data acquisition board, testing interface card, assistant testing set and connecting line with simple configuration.

该系统硬件有运动控制卡和PCL-818L数据采集卡的工控机、测试接口卡和辅助测试台及连接线等，结构简单，可靠性高。

Via Programming of programmable controller and testing of work-piece position by sensor, system running was controlled and fault was checked through man-machine interface.

通过可编程控制器编程，传感器检测工件位置，经人机界面控制装置运行、检测故障。

The design of the multi-channel temperature survey system based on RS-485 and EPP communication interface, and the control principle of PID controller based on fuzzy self-turning model were discussed.

对多路温度检测系统的RS-485串口和EPP并口通信设计和基于Fuzzy自整定的PID控制原理进行详细论述。

This system is composed by a temperature chamber, several switch groups, a PC computer, a high-resolution frequency meter, a frequency standard, a control system including a simulator and a controller, a human interface based on virtual instrument.

该开发系统由温控柜、多路开关组、PC机、高分辨率频率计、频率标准、控制系统、基于虚拟仪器的人机界面组成。

Upon completion of Intelligent Design conference control system, this paper for the conference system terminal controller, the specific implementations discussed in detail, including the main processes, and interface software design and embedded network design.

在完成智能会议控制系统总体设计后，本文针对会议系统终端控制器的具体实现进行了详细讨论，包括主流程以及接口软件的设计与嵌入式网络的设计。

And then, according to the characteristic of intelligent terminal interface unit, the malfunction data collect interface unit is designed which has CAN bus controller based on the research of the data form that the intelligent terminal interface unit dispatched.

然后，根据智能终端接口单元的特点，对该接口单元发送的数据格式进行分析，设计出了带CAN总线控制器的故障数据采集接口单元。

The platform adopted Arm processor to extend thin film transistor liquid crystal display ( TFT-LCD) interface, and acquired the subsystem signals of battery, motor and electric controlling unit by controller area network bus ( CAN-Bus).

采用Arm处理器，扩展薄膜晶体管格式液晶显示器（TFT-LCD）接口，以控制器局部网总线（CAN-Bus）方式，采集电池、电机、电控子系统信号。

The thesis takes the sanyo ECJ-218M electronic rice cooker as application object, implements the serial communication interface connected to the control center by using the I/ O ports and timer interrupt of the MCU of the cooker controller.

论文以三洋ECJ&218M型电饭煲为应用对象，通过电饭煲控制器中单片机的I／O口以及定时器中断实现了串行通信功能，与住宅控制中心相连。

The Interface Timing Design between CAN Controller And ARM Microprocessor

CAN总线控制器与ARM微处理器的接口时序设计

The interface relation between the CCD Timing Generator and CCD controller was also discussed.

给出了它与CCD控制器的接口关系：由CCD控制器给出的指令和数据予以控制。