interfacial reaction的例句大全

High temperature interfacial reaction between granular SiC and Ni in a composite plating

复合电镀层中SiC粒子与Ni之间的高温界面反应

The reinforcements were stable during the thermal exposure, and showed no interfacial reaction with the matrix.

增强体在热暴露过程中稳定性良好，与基体没有界面反应发生。

Interfacial Reaction in Transient Liquid-phase Bonding of Al_2O_3 to Cu with Interlayer of Ti Foil

Al2O3/Ti/Cu瞬间液相连接中的界面反应

It was found by TEM that some new phases exist at the interface after the thermal cycling treatment by 1000 times, and it is considered that this kind of interfacial reaction made the interface bonding strength decreased.

透射电镜观察结果表明，经1000次热循环后，复合材料界面处出现一些新相，破坏了循环处理前良好的界面结合。

In this model, both the effects of the change in the interfacial reaction rate coefficient and the enhanced oxygen diffusion on the high, initial oxidation rate of silicon are considered.

该模型既考虑了界面反应速率系数，又考虑了增强扩散效应对快速初始氧化的影响；

Interfacial reaction of microwave radiating field upon lamellar materials

微波辐射场中的薄层材料界面屏蔽和防护作用的实验研究

Study of the relation between interfacial reaction and formation of Schottky barriers

Pt/Si界面反应与肖特基势垒形成的研究

The interfacial reaction product in carbon fiber reinforced aluminum is dendritic.

碳纤维增强铝的复合材料在制造过程中，由于发生化学反应而在界面上形成新相。

Study on the Interfacial Reaction Product and the Interfacial Wetting Behavior between Ni-Ti Powders and SiC

Ni-Ti/SiC系统的润湿及界面反应产物研究

It is shown that the joint strength increases firstly and then decreases gradually with the increase of joining temperature, and the maximum value of strength is obtained at 850 ℃ because of the effect of ceramic-metal interfacial reaction and residual stress.

结果表明，由于陶瓷／钎料界面反应和界面残余应力的综合影响，随着钎焊温度的增加，接头强度先增加然后逐渐降低，850℃钎焊时接头强度最高。

The Peak Current for a Quasi-reversible Interfacial Reaction of an Adsorbed Substance and Its Verification

吸附物准可逆表面反应示波极谱峰电流及其验证

Optimal interfacial reaction layers with lamella-shaped, serration-shaped and club-shaped morphology were affirmed. Especially, the joint with serration-shaped morphology reaction layer which can prevent crack propagation has the better mechanical property. The result provides a basis for optimization of joint mechanical property.

确认了具有薄层状、锯齿状和棒状的界面反应层能够形成可靠连接，特别是锯齿状反应层有助于抑制裂纹的扩展，具有最佳的力学性能，为接头力学性能的控制提供依据。

Slag-metal interfacial reaction is one of the most important multiphase reactions in metallurgical industry, so improvement on slag-metal interfacial reaction kinetics is beneficial to promotion of metallurgical efficiency.

渣金界面反应是冶金工业中最重要的多相反应之一，因此渣金界面反应动力学条件的改善对于提高冶金生产效率具有重要意义。

Kinetics Study of Compatibilization Blending Interfacial Reaction and 2-Hydroxy-1, 4-naphthoquinone Redox Reaction

共混增容界面反应及2-羟基-1，4-萘醌氧化&还原反应动力学研究

A study of interfacial reaction in resin-matrix composites using infrared substraction spectrometry

红外差示光谱法在复合材料界面反应研究中的应用

the composites ti/ al_2o_3 were sintered by spark plasma sintering at 1 200 ℃ and 30 mpa. the properties of ti/ al_2o_3 interfacial reaction were investigated. the reaction types were measured by x-ray diffraction and electron probe microanalyses.

研究了用放电等离子烧结的Ti/Al2O3在1200℃和30MPa条件下界面反应特性，用X射线衍射和电子探针微区分析了界面反应类型。

The status quo and progress in reaction wetting, reactive brazer, interfacial reaction, joint strength and partial transient liquid-phase bonding were reviewed in this paper. The problems needed to further study are pointed out.

本文综述了近年来在反应浸润、活性钎料、界面反应、连接强度和部分瞬间液相连接方面的研究现状和进展，指出了有待进一步研究的问题。

XPS and in-situ electron paramagnetic resonance ( EPR) spectra were used to examine the interfacial chemical reaction between silane coupling reagent on silica fiber surface and the components of phenolic resin solution.

采用X光电子能谱（XPS）和原位电子顺磁共振（EPR）研究了石英纤维表面硅烷偶联剂和不同酚醛树脂溶液组分间的界面化学反应。

this article, based on high efficiency grinding of si_3n_4 ceramics through half plasticity removal, systematically presented the assistant function of interfacial chemical reaction for increasing the removal rate of si_3n_4 ceramics when various organic grinding fluids represented by alcohols are applied.

本文基于用半塑性去除的方式高效磨削Si3N4陶瓷，系统综述了在使用以醇类磨削液为代表的各种有机磨削液时，界面化学反应对提高Si3N4陶瓷材料去除率的辅助作用。

It was shown that the joint strength depended on the interfacial diffusive reaction between YAS solder and silicon nitride and the thickness of residual glass in the joint.

微观分析表明：接头强度与YAS／Si3N4的界面扩散反应和接头残留玻璃相的厚度有关。