internal connection的例句大全

Stainless steel case and roll ring, polycarbonate lens, brass internal, connection and joint, ( oil-filled gauge ).

不锈钢壳,不锈钢滚圈, 聚碳酸酯面, 铜机芯,铜管子, 铜接头, ( 充油表 )

An Engineering Analysis Approach for Squeeze Equal-diameter Tee Branch Pipe Connection Strength under Internal Pressure

等径挤压三通强度分析工程方法

Stainless steel case and screw-on ring, polycarbonate lens, brass internal, connection and joint, ( oil-filled gauge ).

不锈钢壳,不锈钢旋入式螺纹圈, 聚碳酸酯面, 铜机芯,铜管子, 铜接头, ( 充油表 )

An approximate method for calculating the elastic stresses at the squeeze at the squeeze corner sections of an identical diameter Tee branch pipe connection under internal pressure was presented.

针对石油化工行业大量采用的等径挤压三通，提出了一个计算内压载荷下的纵向平面内挤压圆角处各应力分量的近似方法。

The distribution of the stress in casing connection, the value of make-up torque and thread off load are studied when the casing connection is assembled or loaded with internal pressure and axial tension, which are very important for gluing, leakage and thread off failure analysis.

套管接头在装配、内压和拉伸载荷工况条件作用下，沿接头的应力分布规律、上扣扭矩和滑脱力的大小，对分析套管接头粘扣、泄漏和滑脱的失效有重要参考价值。

The deformations, stresses and strains in the sealing section, shoulder zone, thread surface and tubing body are calculated for the threaded connection under axial tensile loads and internal pressures.

获得了这种特殊扣套管接头密封段、台肩面、螺纹啮合扣面以及管体的应力分布。

Comparing with the traditional method of drawing internal force chart, this method is very simple, it is easy to master and easy to check-up. It unifies drawing shear diagram and bending moment chart using the differential coefficient connection between load collection degree and internal force.

与传统绘制内力图的方法相比，该方法不仅简捷、直观、易于掌握、便于验算，而且和教材中利用载荷集度与内力之间的微分关系画剪力图、弯矩图，形成有机的统一。