internal crack的例句大全

research on the formation of bulge strain and internal crack during bloom solidification

大方坯凝固过程鼓肚应变及内裂纹形成的研究

research on strain and internal crack in cast slab during solidification

连铸板坯凝固过程应变及内裂纹研究

review of formation condition for internal crack in continuous casting slab

连铸坯内裂纹形成条件的评述

analysis on internal crack in continuous casting slab

连铸板坯内裂纹的检验分析

an investigation on prediction model of internal crack of cc slab

连铸板坯内裂预测模型研究初探

Influence of mold wear on internal crack formation in continuous casting of steel billets

结晶器磨损对连铸小方坯内裂纹形成影响的研究

When the tensile stress of the core layer is bigger than the tensile strength perpendicular to grain of wood, the internal crack will appear.

心层的拉伸应力与木材内裂有关，当心层拉伸应力超过木材横纹拉伸极限强度时，木材产生内裂。

sem analysis show that after the fast neutrons irradiation, b4c coating internal crack, eds analysis did not detect b.

SEM分析表明，B4C涂层经快中子辐照后，涂层内部出现裂纹，EDS未检测出B。

elastic interaction between a wedge disclination dipole and an internal crack

楔型向错偶极子和裂纹的干涉效应

through the analysis of h_1~ n curve for cylinder with an internal axial crack, this paper determines the normalised load for this cracked body, and gives the estimation formula of strain hardening exponent in a widened interval.

通过分析含轴向内部裂纹圆筒的h1～n曲线，给出了这种裂纹体的标准载荷和关于应变硬化指数的拓宽范围内的估算公式。

The internal and surface cracks in rolls were detected with magnet as exciting source. Quantitative detection of cracks was realized by the establishment of mathematical model according to magneton theory and quantitative analysis of crack signals based on the piecewise cyclic approximation of neural network.

以磁为激励源进行轧辊表面及内部裂纹缺陷的检测，基于磁荷理论的裂纹数学模型的建立和神经网络的分段循环逼近的裂纹信号定量分析，实现了裂纹无损定量检测。

Sensitivity coefficient obtained from calculation can represent how much the internal temperature variation and contraction affects the early crack of concrete structure.

计算得到的敏感系数能够表示结构内部温度变化和收缩这两个因素对于混凝土结构早期开裂的影响程度。

Combined with the analysis of original stress state of existing tunnel considering segment joints, the important internal causes of crack are found out.

结合对考虑拼接缝的既有隧道管片受力状态的分析，找到裂缝隔片产生在连接块上的重要内在原因。

By analysis, FT or UT is suitable for testing surface and near surface crack of large parts, and UT is suitable for internal tiny crack.

通过分析，得出检测大型部件表面和近表面缺陷时，选用涡流或超声波检测方法，检测埋深较大的内部微裂纹时，应用超声波进行定位定量检测；

Comprehensive analysis on floor plate crack is carried out according to the displacement field, stress field and internal force of the floor plate.

根据楼面的位移场、应力场、弯矩和轴力值，对楼板开裂进行了综合分析。

Stress Intensity Factor Research about a Thick-walled Cylinder with an Internal Semi-elliptical Surface Crack

厚壁筒内表面椭圆裂纹的应力强度因子研究

Feasibility Analysis of Internal Detection Technology for Crack in Spiral Seam Pipeline

裂纹内检测技术应用于管道螺旋焊缝的可行性分析

On the bases of calculations and analyses as above, the simple and conservative formulae calculating SIF KI for inside corner crack of nuclear vessel nozzle under internal pressure are obtained.

进一步计算分析了柱接管内壁角裂纹应力强度因子K1及其与裂纹和结构几何参数关系。

Rock failure can also be seen as a process of their internal structure surface formation and reconstruction, the micro-crack initiate, macro-crack formate, structure surface slide along the contact surface in this process.

岩石破坏过程也可看成是其内部结构面形成、重构的过程，在这个过程中，微裂纹萌生、宏观裂纹形成、结构面贯通及沿接触面滑移等现象交织在一起。

The Normalised Load and Application for Pressurized Cylinder with Internal Axial Crack

含轴向内部裂纹圆筒的标准载荷及其应用