joint effect的例句大全

Joint effect of the new and old continuous steel bridge analyzed by gridiron method

用梁格法分析新旧连续刚构桥的拼接效应

the world investment report in 1996 has clearly pointed out that the relation between the fdi and international trade is extremely critical. holding the relation, it will have a joint effect and have a more widespread and profound influence on economic growth and development.

《1996年世界投资报告》中明确指出：国际直接投资与国际贸易之间的联系十分重要，抓住这种联系就会产生一种合力，对经济增长与发展产生更广泛、更深刻的影响；

Major problems of Rapid Prototyping ( RP) in StereoLithography ( SL) were deformation and overall joint effect.

光固化原型制作过程中存在的主要问题是变形和表面台阶效应。

Joint effect of Gastrodia elata blume and Donkey-hide gelatin on the content of nitric oxide in hippocampus and the ability of learning and memory during lead administration in rats

天麻和阿胶联合对染铅大鼠海马一氧化氮含量及学习记忆的影响

Joint Effect of Vitamin C, Vitamin E or Selenium on Cell Lipid Peroxidation Induced by Cadmium in LLC-PK_1 Cells

维生素C、维生素E、硒与镉联合作用对LLC-PK1细胞脂质过氧化的影响

The late period of the War saw the shrink of the private industries under the joint effect of currency inflation, competition from the state-run industries and improper price-control policy.

到抗战后期却在通货膨胀、国营工业竞争和不科学物价管制政策联合作用下走向衰落。

With the joint effect of wind and wave, the superposition of maximum wave loads and random wind loads can be generally considered as the critical load case of load effect combination.

在风、浪联合作用下，最大浪荷载叠加随机风荷载时程工况一般可作为荷载效应组合的控制工况。

The root cause of Lin Daiyu's tragic love, in my opinion, is the joint effect of her "individualism" and "putting love above everything else".

红学界普遍认为，林黛玉的婚姻悲剧是封建礼教叛逆者的悲剧。

Transient liquid phase ( TLP) bonding was applied to join TP304H stainless pipe, and the effect of bonding temperature on joint microstructure and mechanical properties was studied.

采用瞬时液相扩散焊（TLP）连接技术进行了TP304H不锈钢管的焊接，分析了不同焊接温度对接头组织、成分和力学性能的影响。

The effect on the microstructures of the brazing seam of Ag-CdO contact terminal and Cu contact bridge by different brazing technological parameters including temperature, holding time and joint gap was analyzed. Based on the analysis, the optimum technological criteria put forward.

分析了Ag-CdO触头与Cu触桥钎焊温度、保温时间、钎焊间隙对钎缝组织的影响，并提出了获得理想组织的最佳工艺规范。

Effect of botulinum toxin A in improving the activity of carpometacarpal joint of thumb and spasm

A型肉毒毒素改善脑性瘫痪患儿拇指腕掌活动度及痉挛状态

Therapeutic effect of acupuncture and cupping combined with manual reduction on small joint derangement of the thoracic vertebra

针罐配合手法复位治疗胸椎小关节紊乱疗效观察

Research and Application of Pterygoid Steel Plate for Internal Fixation of Fracture of the Lateral Malleolus Associated with Isolation of the Inferior Tibiofibular Joint The effect of alar ligament fragmentation on the stability of atlanto axial joint

内固定外踝骨折并下胫腓分离弧翼状钢板的研制及应用翼状韧带断裂对寰枢关节稳定性影响的生物力学实验研究

Effect of external therapy on tissue repair of immobilized joint

外治法对固定关节组织形态修复的作用

Analysis of Therapeutic Effect of Three Operations in Treatment of Acromioclavicular Joint Dislocations

肩锁关节脱位27例疗效分析

The effect of the sheet rigidity on strength of the spot weld tension shear joint

薄板刚度对点焊接头强度特性影响

Effect of heating rate and holding time on microstructure of brazing joint is analyzed.

观察并分析了升温速率及保温时间对接头显微组织的影响。

The lap joint produces bending effect under the action of tensile load and the bending degree decreases with the increase of yield limit of base material.

搭接接头在拉伸载荷作用下会产生折弯效应，折弯程度随被钎焊母材屈服极限的增加而减小。

Objective To assess the clinical effect of microsurgical treatment for bone defect of the first carpometacarpal joint.

目的报道第1腕掌关节缺损显微外科修复的临床效果。

It is shown that the joint strength increases firstly and then decreases gradually with the increase of joining temperature, and the maximum value of strength is obtained at 850 ℃ because of the effect of ceramic-metal interfacial reaction and residual stress.

结果表明，由于陶瓷／钎料界面反应和界面残余应力的综合影响，随着钎焊温度的增加，接头强度先增加然后逐渐降低，850℃钎焊时接头强度最高。