layer corrosion的例句大全

External layer corrosion was aroused mainly by steam.

外部层板的腐蚀主要是蒸汽介质引起的。

plating layer corrosion or wear;

电镀层被腐蚀或磨损的；

Pitting, crevice corrosion and layer corrosion occurred on 180 YS and LF 21 M.

LF21M除点蚀 、 缝隙腐蚀外还发生层间腐蚀.

The rust layer accelerates the matrix corrosion in the worsening sequence of full submersible zone, tidal range zone and splash zone.

锈层将促进基体的腐蚀，其程度依全浸区、潮差区、飞溅区的顺序增加。

Thermal shock test, microscopy, micro-hardness, wear resistance and corrosion test were used to study the relation of microstructure and properties of brush plated NiW ( D) layer with brush-plating voltage.

通过金相观察，显微硬度，磨损试验，腐蚀试验及热震试验，研究了NiW（D）合金电刷镀层的组织、性能与工作电压的关系。

The reaction of the interface layer did not significantly reduce further corrosion.

反应生成的界面层并不能明显降低腐蚀进一步发生的速率。

Copper in hot rolling copper containing steel plate can passivate the cathode anode of corrosion reaction on plate surface and form a dense anti rusting layer, so the rusting reaction is postponed and prevented so the corrosion resistance is enhanced.

车辆用含铜热轧钢板中的铜在钢中可以钝化钢板表面腐蚀反应的阴阳极，或者形成致密锈层，延缓、阻止锈蚀反应进行，提高耐蚀性。

Polishing can reduce the surface roughness of silver flan, but the polishing affected layer and residual polishing agent accelerate the formation of corrosion battery, which results the acceleration of silver tarnishing.

抛光能降低银的表面粗糙度，但是抛光过程中形成的加工变质层和残留抛光剂加速了腐蚀原电池的形成，使银币的腐蚀变色速度加快。

the experimental results show that the laser cladded layer of the specimen possesses higher hardness, wear and corrosion resistance.

试验结果表明，激光熔敷层具有较高的硬度和良好的耐磨抗蚀性能。

The research of inductivity coupled plasm atomic excite spectroscope on atmosphere corrosion rusty layer

大气腐蚀锈层的电感耦合等离子体光谱研究

the high corrosion resistance of the amorphous ni-p alloy deposits is attributed to the phosphorus enrichment on the surface and formation of a protective barrier layer as a hypophosphite anion or a compound ni_2p.

文中还指出，非晶态Ni-P合金高耐蚀的原因，是由于合金表面磷的富集，生成次亚磷酸根阴离子（H2PO2~-）或Ni2P化合物的保护层，使合金进入钝性状态。

Electrochemical Techniques for Measuring Anti-corrosion Behavior of the Thin Corrosion Inhibitor Layer to the 907A Steel

薄层缓蚀剂液膜对907A钢防蚀效果的电化学测量技术

Effect of oxygen on Corrosion Resistance of Nitriding White Layer on A3 Steel and Grey Iron

氧对A3钢和灰口铸铁氮化白层抗蚀性的影响

The phase composition and microstructure of corrosion layer of the attacked specimen was examined by XRD and SEM.

试验完成后，用XRD分析坩埚试样侵蚀层的相组成，用扫描电子显微镜观察坩埚试样侵蚀层的显微结构。

Study of tensile stress generated by dezinc layer during corrosion for Brass

黄铜静态腐蚀脱Zn层引起拉应力的研究

corrosion layer of bronze relics consisted of red cuprite sub-layer, green carbonate mineral sub-layer and yellow stannolite sub-layer.

腐蚀层细分为红色赤铜矿层、绿色碳酸盐矿物层和黄色锡石层组成，其厚度小于1mm。

Study on the Compositions in the Interface of Corrosion Inhibition Membrane/ Copper Plating Layer/ Iron Substrate by Depth Etching and Photoelectron Spectroscopy

采用深度刻蚀与XPS能谱研究缓蚀膜/镀铜层/铁基体界面成分

in the humid air can form a layer of oxide film to prevent metal corrosion.

在潮湿空气中能形成一层防止金属腐蚀的氧化膜。

surface depletion layer and its influence on the corrosion morphology for aiuminum-linthium alloys containing cerium

铈对铝锂合金表面贫化层及其腐蚀形态的影响

two corrosion layers can be found on 316 stainless steel after being corroded for 24h, the first blacker layer near the base is fe_2al_5, and the second outer layer with spot is feal_3.

316不锈钢经过24h的腐蚀，可看出腐蚀层分为两层，靠基体较黑的为第一层Fe2Al5，往外花带斑点的为第二层FeAl3。