load operation的例句大全

This paper has determined the real power economical operating zone of a three circuit transformer through analysing and calculating its economical load factor and optimal economical load factor, then given a reliable theoretical guidance to the economical operation of three-circuit transformers.

本文通过对三绕组变压器有功经济负载系数和有功最佳经济负载系数的分析，确定出三绕组变压器的有功经济运行区，为指导三绕组变压器有功功率的经济运行提供了理论依据。

But Guangzhou port has only five special container berths, the annual throughput capacity is 205 million TEU. The berths remain over-loading operation status. The conflict between the high-speed of container cargo volumes and the lack of the throughput capacity is more and more serious in Guangzhou.

然而广州港集装箱专业化泊位仅有5个，通过能力仅为205万TEU，目前的泊位处于超负荷运转状态，集装箱吞吐量快速增长与码头通过能力不足的矛盾日益突出。

Optimization of Coordinated Control System during Low-load Economic Operation of 600 MW Units in Taishan Power Plant

台山电厂600MW机组低负荷经济运行协调控制系统优化研究

Steelmaking EAF with larger load oft he distribution network would produce large impact and interference on the public electric network in operation.

配电网中较大负载的炼钢电弧炉在运行过程中会对公用电网产生较大的冲击和干扰。

Heat Load Prediction Based on Neural Network and Operation Optimization in Electric Boiler with Heat Accumulator

基于人工神经网络的热负荷预测及蓄热式电锅炉系统运行优化

If the first reference to a class C occurs during a time-critical operation, then the time to resolve, verify, load, and initialize C might cause that operation to take longer than expected.

如果对一个类C的首次引用发生在时间关键型操作期间，那么解析、验证、加载和初始化C的时间可能导致执行操作的时间比预期更长。

Closed-loop soft water cooling system shall be controlled fully automatically and necessary consideration shall be taken on such critical aspects as anticorrosion measures, water quality, control on water temperature difference ( At) and hot load ( Q) to assure normal operation of the system.

软水密闭循环冷却系统应实现全自动控制，考虑必要的防腐措施、水质问题，水温差（Δt）和热负荷（Q）参数的控制等关键因素，以保证系统的正常运行。

HP by-pass system with safety valve function and a capacity of 100% rated load ( RL), cooperating with 60%~ 70% RL low-pressure by-pass system, can handle various conditions during startup and operation of units.

具备安全阀功能的100%额定容量（RL）高压旁路系统与容量为60%～70%RL的低压旁路系统配合，可处理机组启动和运行中所出现的各种情况。

Preparation and Application of Standardized Operation Card for On-load Test of Transmission Line

线路带负荷测试标准化作业卡的编制与运用

Wide attention is paid to electronic load scale attached to crane hook to insure safe crane operation.

为保证起重机的使用安全，钩头动态电子秤受到了工矿企业与港口码头的普遍重视。

Comments on the operation of ammonia synthesis section with high load

我公司氨合成工序高负荷运行浅析

Test and Failure Judgment in the Operation of On-Load Tap Changer of Transformer

变压器有载分接开关运行中的测试和故障判断

In order to improve power supply reliability and economy, the modern power system were powered by a transformer on-load tap transformer parallel operation of technology and techniques.

为了提高供电的可靠性和经济性，现代电力系统大都采用了变压器有载调压技术和变压器并列运行技术。

Parallel operation between distributed generator and distribution system can exploit its advantages to the full and improve the reliablity of power supply. Under-load tap changing transformer is modeled using a switch function, and the impact of distributed generator outage is included.

分布式电源与电网并网运行能够充分发挥其优势，并且提高供电可靠性.该模型的特点是能够模拟有载调压变压器、分布式电源事故停运以及多个分布式电源的情况。

This paper analyzes the influence of the error of the transformer normal tapping ratio, short-circuit resistance and the load of plant power supply on parallel operation, and calculates the difference between the allowable loads for different units while parallel operation conditions are satisfied.

文中分析了变压器变比误差、短路阻抗对并联切换的影响，计算了满足并联切换条件时机组间的允许负荷差异。

The galloping of iced conductor caused by wind load severely imperils the safe operation of the high voltage transmission line.

覆冰导线由于风载而造成的舞动，严重地威胁着输电线路的安全运行。

Manual Switch Operation : Under load, with door closed and with either or both sources energized operation.

手动开关操作: 欠载, 闭门状态,任一源或者所有源通电.

is important to achieve a proper load division in the parallel operation of transformers.

此外，要实现变压器并联运行时的恰当负荷分配，阻抗值是重要的。

the result provides theoretical basis for power enterprises to evaluate the benefits from load management, in addition, it makes a reference for power enterprises to optimize their production and operation.

本分析结果可为电网企业分析负荷管理发挥的效益提供理论依据，为优化电力企业生产运营提供参考。

process documents-loading plan, spots distribution, operation sequence, cycle time, and so on;

工位的工艺文件-上件图，焊点分配图，动作时序和循环时间；