loading condition的例句大全

it has been shown that under heat loading condition, it has a limit working temperature.

研究表明，当复合管处于热加载状态时，复合管存在着极限工作温度；

The acquisition of ship motion and wave loading is based on the linear response of ship in harmonic wave and calculated by ship with no speed running beam sea, which is believed the most dangerous loading condition for SWATH ship according to the ship model testing results.

确定船体运动和波浪载荷的方法是以谐波中船舶的线性响应为基础，按零航速横浪来计算的。根据模型试验结果此种状态是SWATH最危险的载荷状态。

From the experimental data, it shows that the mechanical behavior of the concrete exhibits anisotropy and is obviously different from that of the quasi-static loading under high rate of loading condition.

混凝土的实验数据表明其力学性质表现出很强的各向异性，并且在高加载速率的情况下，混凝土的性质和准静态时明显不同。

A new non-linear constitutive model for normal consolidation soil under static loading condition is presented.

提出了一种新的、适用于正常固结土在静荷作用下的应力矢量型非线性本构模型.

Effect of simple loading condition on relation between load and displacement of cracked specimen

简单加载条件对裂纹试样载荷&位移关系的影响

Biaxial stress-strain curves of biaxial compression and compression-tension were obtained under biaxial strain-controlled loading condition.

在应变控制加载的条件下测得了混凝土板式试件在二轴压-压区和拉-压区的双轴应力应变全曲线。

In this paper, the problem of a steadily spinning disk under uniformly distributed pressure is investigated by the use of perturbation method. The asymptotic solutions of stresses and deformations under the loading condition of JV2/ JII 1 is obtained.

本文对中心带轴匀速旋转圆盘在均布压力作用下的受力及变形问题进行了摄动分析，得到了受载条件为J v~2/J H1时，圆盘应力及形变的渐近解。

The experiments of obtaining stress strain curves in cyclic loading condition are investigated, and the measure-ments of the stress strain curves in reverse loading by using sheet metal compression test and three-point bending test are clarified.

对材料在循环加载条件下应力应变曲线的实验获取方法进行了探讨，重点介绍了板料压缩、三点弯曲实验确定材料反向加载应力应变曲线的原理和方法；

Effect of Different Loading Condition on the Tribology Characteristics of POM Composite

不同加载条件对聚甲醛复合材料的摩擦学性能影响

Poor loading condition will severely limit the supporting capacity of the supports in soft strata.

受力条件恶化严重抑制着软岩巷道支架支撑能力的发挥.

Unlike loading condition of secondary stress which cause distortion , peak stresses cause no significant distortion.

与引起二次应力的载荷不同, 峰值应力对管道来说产生的破坏性不重要.

But when the flow rate increased the influences of the bed structure, the way of loading bed material and the operating condition on the curve of pressure drop-velocity were relatively great.

上行程曲线受床体结构、物料装填方式和运行状况的影响很大。实验测定初始流化速度应采用下行程曲线。

With perfect practicality and economy, the allowable value of the extreme installation height for loading arm is given on no air-lock condition at certain temperature and flow rate, and also given is a pro-

给出了一定温度和流速时无气阻条件下的鹤管允许极限安装高度值，以及无气阻条件下的工艺参数范围，具有实用性和经济性。

under the dry sliding wear condition, especially with high loading, the wear resistance of the composite coating is much higher than conventional al2o3 coatings.

在干摩擦磨损条件下，尤其在高载荷作用下，复合涂层的耐磨性明显高于普通Al2O3涂层。

the experiment results of sample reducer prove that the loading capacity of new designed product series is much higher than primary one under the same condition.

新产品系列中样机试验的结果也验证了其比原规格大小的三环减速器的承载能力有了很大提高。

According to the relation between the changes of the characteristics of the Acoustic Emission and stress condition, the sandstone and granite samples fracturing process both can be divided into three stages: the early loading stage, the medium loading stage and the late loading stage.

将砂岩和花岗岩样本的压裂过程和各自的声发射信号的规律的变化结合起来可以分为三个阶段，即加载初期阶段、加载中期阶段和加载后期阶段。并且它们具有各自不同的特征。

The curve of loading and deformation veried that bamboo and wood composite plywood mainly showed low-temperature brittleness and hot brittleness when treated in cold water, frozen condition, and drying.

负荷挠度曲线表明，竹木复合胶合板在冰冻、冷水、干热下表现为脆性破坏为主，热水处理时的性能变化表现出粘弹性为主的特征，竹木复合材料的静态力学性能表现与其粘弹性变化机理相关。

Results LJP could lengthen the weight loading swim time and the survival time of the experimental mice under the condition of hypoxia that was carried out in the normal atmosphere pressure.

结果海带多糖能显著的提高受试小鼠负重游泳时间和常压缺氧下存活时间，并能升高受试小鼠的血红蛋白；

There is essential difference between the mechanical condition of unloading engineering rock mass and loading engineering rock mass.

卸荷状态工程岩体的力学条件与传统的加载岩体有本质的区别。

In addition, the dry friction coefficient is 0.44 at the condition of 147 N loading.

块体材料在147N的载荷作用下, 其干摩擦系数为0.