lower edge的例句大全

He caught his lower lip with the edge of white, even teeth.

他那洁白平整的牙齿咬着下唇.

the way of crack elimination is to set the vertex of higher resolution node to the edge of conterminous lower resolution node.

另外，通过将较高分辨率节点的顶点移到相邻较低分辨率节点的边界上的方法消除裂缝。同时，进行了实验研究。

Position the front door lower weatherstrip on the door inner panel aligning tape to bottom edge and press into place.

将前车门下部防水饰条移至车门内侧饰板上并将其与下边对齐，按压到位。

Quick-point grinding is a new type of high and super-high speed grinding process with a point contact zone and lower grinding power, and the edge effect of the air barrier is weakened because of the thin super abrasives grinding wheel.

快速点磨削是一种新型高速/超高速磨削技术，接触区很小，实际磨削功率低，冷却及散热效果好。

Four irrigation fertilization strategies, nitrate content are all lower than the background value in wet area internal. Nitrate concentration accumulated at the wet front edge.

四种灌溉施肥策略下，湿润体内部的硝态氮含量均低于本底值，主要累积在湿润锋边缘。

With changes in external environment, more and more firms adopt flexible employment pattern to lower the management cost so as to win more competitive edge.

随着外部环境的变化，越来越多的组织采用灵活就业的人员配置形式，由此带来了组织管理控制成本的降低和组织应对市场竞争更具弹性等方面的优势。

the upper and lower oven fire 150 degrees 15 minutes, roasted to edge coloring.

进烤箱上下火150度15分钟，烤至边缘着色即可。

Practice this until you can lift and touch the lower ski to uphill boot at least five times in the traverse, without losing your balance and without diminishing the grip ofthe uphill, little-toe edge.

现在，斜滑降时，用山上板的外刃，提起山下脚，并靠近接触山上脚，保持平衡，横穿雪道。

5-8 gill rakers in lower limb of first arch (ref. 12693). has 15-19 serra along posterior edge of last simple dorsal ray (ref. 43281).

在第一鳃弓的下肢中的5-8个鳃耙。（参考文献12693）使15-19个锯齿沿著最后单一的背鳍鳍条的后缘。

During experiments of lower hybrid wave current drive, the change of LHW drive power will be accompanied by the change of the edge electric field, poloidal rotation velocity and Reynolds stress.

在低杂波注入实验中，改变低杂波驱动功率，从而改变边缘电场、等离子体旋转速度和边缘静电雷诺胁强。

The old tool carriage with point contact crop appearance for steel pipes is not suitable to cut the oblique end face on pipes because of tool edge bluntness and lower tool service life.

传统的钢管平头方式&点接触平头方式设计的刀盘，对于切斜的管端面很不适应，易打钝刃口，降低刀具使用寿命；

Lower motor assembly into hole with switch facing left edge of baseassembly should not touch base.

放马达组合入洞时让电源开关靠近基座左边,并且不能接触基座.