main turbine的例句大全

at higher speeds, the main turbine takes over.

高速航行时，主涡轮机接管工作。

The main contents are: 1. a simple temperature and enthalpy chart set up by energy conservation law, after the structure and operating principle has been analyzed as basic three components of the gas turbine& air-compressor, combustion chamber and turbine.

主要研究内容有：1.对燃气轮机的基本组成三大部件&压气机、燃烧室、透平组成结构，工作原理进行分析，根据能量守恒定律建立简单的温焓图。

Analysis and computing of main shaft of water turbine based on rotor bearing system

基于转子轴承系统的水轮机主轴的分析计算

This article contains three optimization goals: following the load instruction, reducing the throttling losses of turbine high-pressure main steam valve and reducing the amount of fuel.

本文的优化目标有快速跟踪负荷指令、减少汽机高压主汽门节流损失和减少燃料量。

Through welding characteristic analysis of No. 8 turbine blade material in Shizuishan Power Plant, particularly analyzes technique main points of blade welding, carefully introduces on-site weld repair technique plan and concrete process of turbine blade.

通过对宁夏石嘴山发电厂8机汽轮叶片材料的焊接性和焊接工艺要点的分析，详细介绍了汽轮机叶片的现场焊接修复工艺方案及具体过程。

The low pressure exhaust hood is an important through-flow component of a steam turbine. Its main function is to partially recover the turbine leaving kinetic energy into potential energy.

汽轮机低压排汽系统是汽轮机通流部分的一个重要部件，它的主要作用是对汽流扩压把汽流的余速动能部分的转化为压力能。

The design of the running simulation system of water turbine actiyator is based on Microsoft software and hardware. The main work is the design of software system, and the key part is to establish the mathematics model of simulation system.

水轮机调速器运行仿真系统的设计是基于微机的软、硬件系统的，其中主要的工作是软件系统的设计，而建立仿真系统的数学模型是设计的关键。

Cause and treatment of HP main stop valve jam on a 300 MW steam turbine

300MW汽轮机高压主汽门卡涩原因及其处理

analysis of bolt fracture failure for high-pressure main stop valve of turbine

汽轮机高压主汽门螺栓断裂失效分析

cause analysis of unsmooth blockage occurred on high-pressure main steam valve of steam turbine and preventive measures thereof

汽轮机主汽阀卡涩原因分析及防范措施

Excessive vibration of the steam turbine unit is one of the main reasons for failure, which affects the safety and economy running.

过大的振动是汽轮机组故障的主要原因之一，它影响了机组的安全经济运行。

Structural analysis of wind turbine main shaft using nonlinear contact method

风力发电机主轴的非线性接触有限元分析

Similarity Algorithm of Process and Its Application for Turbine Main Shaft

基于特征层次模型的汽轮机转子主轴相似工艺的判定算法及其应用

Analysis and Treatment of Water Turbine Main Shaft Seal Fault Reason

水轮机主轴密封故障原因分析及处理

In accordance to analysis of interaction mechanism between the ejection and the main flow, a 2-D compressible model of the turbine blade trailing edge ejection has been improved, which uses energy loss coefficient for representing the effect of the ejection on the aerodynamics of the main flow.

本文分析了叶片尾缘喷气与主流干扰的机理，改进了二维、可压缩的涡轮叶栅尾缘喷气模型，并以能量损失系数ξF来反映冷气喷射对主流的气动影响。

A New Measure to Seal Main Shaft of Hydraulic Turbine

水轮机主轴密封的新措施

The Structural Optimization Analysis of Main Shaft Transition for Large and Medium Hydraulic Turbine

大中型水轮机主轴过渡段结构的优化分析

Air Admission to Main Shaft Central Hole in Hydraulic Turbine

水轮机主轴中心孔补气

With the continuous improvement of steam turbo-generator capacity and main steam parameter, in order to guarantee the efficiency and security, the real-time and accuracy requirement of temperature measurement for the turbine rotor surface is improved at the same time.

随着现代汽轮机发电机组单机容量和主蒸汽参数的不断提高，为了确保机组效率和安全性，电厂对汽轮机转子表面温度检测的实时性和准确性要求也日益提高。

The background, system layout, main functions and evaluation of retrofitting electro-hydraulic control system for 2 steam turbine driven feed-water pumps of unit No. 2 in the first-phase project of title power plant have been presented.

介绍华能上安电厂一期工程2×350MW机组2号机2台给水泵汽轮机电液调节控制系统（MEH）改造背景、系统配置、主要功能及其评价。