mechanical cooling的例句大全

Forced draft mechanical cooling tower dry type air cooler

鼓风式机械通风冷却塔干式空气冷却器干式冷风机

development of mechanical cooling technology and its application to space remote sensing

机械制冷技术在空间遥感领域的应用与发展

The mechanical parameters of the cooling tube with spiral flute were measured by the tension and fatigue tests.

由拉伸和疲劳试验，测定了冷凝器用钛螺纹槽冷却管的力学参数；

Effect of Accelerated Cooling on the Microstructures and Mechanical Properties of Controlled Rolled HQ Steel

加速冷却对控轧HQ钢组织性能的影响

Scale prevention and low pressure steam cooling for mechanical sealing of metal bellows expansion joints

金属波纹管机械密封结垢处理与低压蒸汽冷却

based on the comprehensive technical retrofits for the mechanical and electrical equipment of ( xin'anjiang) hydropower plant, the components, controlling and networking methods of a kind of plc cooling controller for force oil-air cooling transformers are recommended.

结合新安江水电厂机、电设备的全面技术改造，介绍了一种强油风冷变压器的PLC冷却控制器的组成和控制、组网方式。

Whilst the rapid cooling ensures good mechanical properties, the thermal gradient can be large enough to produce high levels of residual stress.

然而快速冷却虽然保证了合金良好的力学性能，但温度梯度会造成很高的残余应力，降低冷却速度会减小残余应力，但也降低了其力学性能。

As a important research institute majored in infrared remote sensing in China, SITP puts emphasis on the study of hardcore technologies such as passive cooling, mechanical refrigeration and space application technologies.

中科院上海技术物理研究所作为我国空间制冷技术研究的主要单位之一，最近几年在空间机械制冷、辐射制冷以及相关技术的研究和应用方面取得了显著的进步。

effect of chemical composition and cooling process on microstructure and mechanical properties of multiphase steel and martensite steel

成分及冷却工艺对复相钢、马氏体钢组织与性能的影响

the wear calculation of mechanical seal for ethylene cooling agent compressor

乙烯冷剂压缩机机械密封磨损计算

mechanical design of permanent magnet linear synchronous motor cooling system

永磁同步直线电动机冷却系统结构设计

according to the experimental data, from the amount of air into the tower, spray water, the air wet bulb temperature, cooling coil diameter, ratio of air to water to discuss five aspects of closed-cooling tower with the mechanical ventilation the case of thermal performance.

根据实验数据，从入塔空气量、喷淋密度、空气湿球温度、冷却盘管管径、气水比等五个方面讨论了机械通风闭式冷却塔内的热工性能的情况。

it has been made clear that the cause of cracking occurred in the upper part of the walls of the cooling water chamber on the cylinder head is due to mechanical loads, especially the loads caused by the screws on the cylinder head.

指出气缸盖冷却水腔上部壁处产生裂纹的原因是机械载荷，其中特别是气缸盖螺钉引起的载荷尤为重要。

rotating mechanical seals for agitator shafts; designation, sealing liquid, cooling, inspection and mounting connections

搅拌轴的滑动环密封.标识.密封液体.冷却.检验及装配连接

Fan is one of key components of mechanical ventilation cooling tower.

风机为机械通风冷却塔的关键部件.

Other work including training other mechanical engineer, forecasting new cooling method.

其他工作包括培训其他机械工程师, 预测冷却方法的发展趋势.

Remark : Applied to zone of transition sintering , cooling and working ling of mechanical shaft kiln.

系列磷盐砖用于水泥回转窑的过渡带、冷却带 、 冷却机及机窑的工作层.

MARC deformation simulation and the prediction of mechanical properties after cooling were discussed subsequently.

MARC有限元变形模拟之间的集成问题,以及冷却过程中的组织变化和性能预报问题.

Effects of the type of press quenching, the cooling velocity and the delay time before press run-out quenching on the microstructures and mechanical properties of Al-Mg-Si ( 6005A) hollow sections were investigated by orthogonal optimizing method.

采用正交试验和模拟试验的方法，研究了在线淬火方式、淬火冷却速度及淬火延迟时间对6005A铝合金空心型材组织和性能的影响。

A combined cycle refrigeration system ( CCRS) is a new energy saving cycle consisting of the refrigeration cycle using mechanical compressor ( RAC/ MC) and the ejector cooling system using ejector ( EJC).

CCRS是使用机械压缩机的制冷循环（RAC/MC）和使用喷射器的冷却循环（EJC）复合的一种新型节能循环系统。