mechanical loss的例句大全

friction loss takes the most amount of the mechanical loss in internal combustion engines.

在发动机功率损失中，摩擦损失占相当大的比例。

mechanical loss analysis and calculation of diving oil motor

潜油电机机械损耗的分析与计算

The Prediction of Mechanical Loss in High-Speed DI Diesel Engine

高速直喷柴油机机械损失的预测

The utility model can save labor and decrease mechanical loss caused by the negligence of people.

其优点是节省人力、减少人为疏忽造成的机械损耗。

heat loss due to mechanical incomplete combustion

机械未完全燃烧热损失

The test results show that the zinc coat loss can be reduced as pass draughts increase by raising work cone angle rationally and reducing the bearing length, but which has not obvious effect on the mechanical properties of finished steel wire and the service life of die.

试验结果表明部分压缩率增大时，合理增大工作锥角度、减少定径带长度，可减少锌层质量损失，而对成品钢丝的力学性能和模子寿命影响不明显。

to predict mechanical incomplete combustion heat loss in power plant boilers with artificial neural network

应用人工神经网络预报电站锅炉的机械不完全燃烧热损失

high mechanical incomplete combustion heat loss analysis and control measures in operation

机械未完全燃烧热损失偏高原因分析及运行中控制措施探讨

a discussion of measure methods of mechanical incomplete combustion heat loss in cfb boilers

循环流化床锅炉机械不完全燃烧热损失的影响因素及测定

During working process, such mechanical failure as teeth breakdown of transmission system and plastic deformation of load flat appears frequently, which result in the break of production, even the paralysis of whole product line, so tremendous economic loss is inevitable for corporations.

工作过程中常常出现传动系统齿断、载荷平台塑性形变等机械故障，由此导致生产断续，甚至造成整条生产线瘫痪，给企业带来巨大经济损失。

Some silicone resins ( RTV) were screened and the signature penetration, thermal weight loss, mechanical and adhesion properties for RTV were tested.

对多种硅氧烷树脂（RTV）进行了筛选和信号透过率、热失重、力学及粘接性能试验。

Results indicate that the addition of right amount of PBT with low viscosity, ethylene copolymer A, rosin ester A and rosin ester B could improve the flowability of the composites to some extent without loss of their good mechanical properties and flame retardancy.

结果表明，适量加入低粘度PBT、乙烯共聚物A、松香酯A、松香酯B可使体系在保持综合性能较好的前提下，流动性能得到不同程度的改善。

In this paper, we discuss the nature of half-wave loss about mechanical wave, electromagnetic wave and matter wave respectively.

本文分别讨论了机械波、电磁波、物质波在两种介质的分界面正入射传播时产生半波损失的本质。

The dynamic model focuses on the mechanical analysis of the swash plate and the shaft, analyzing the power loss.

动力学模型分析了活塞、斜盘和主轴的受力，计算了摩擦功耗，分析了斜盘腔压力对排量的控制。

This result suggests that there may be some loss in mechanical stability in overlapping fixed greater tuberosity.

提示采用重叠方式对大结节进行固定，可能会在抗外旋稳定性上出现损失。