meshing point的例句大全

The biggest tension is at meshing point of driving gear and this value is very big.

锯链的最大张力发生在驱动链轮啮入点附近，其数值相当大。

A New Method for Solving Instant Meshing Point of Real Tooth Surface& Zero Gape Method

真实齿面瞬时啮合点求解算法的研究&零间隙法

Using the contact temperature criterion of Block, the simulation results of the flash temperature and contact temperature of the meshing point are obtained, which provided scientific warranty for optimum design of gear transmission.

运用Block接触温度准则，得出齿轮各啮合点瞬现温升及接触温度变化的仿真分析结果，为齿轮传动结构的合理优化设计提供科学依据。

through analyzing the explanation of traditional working principle of hydraulic gear pump, the article points out it is incorrect that the seal volume variation of oil absorption and oil pressure are generated by the change of meshing point.

通过分析液压齿轮泵传统工作原理的解释，指出齿轮泵由于啮合点变化产生吸、压油区密封容积变化的观点是错误的。

once your point cloud is free of obvious noise, you are ready to run the meshing steps to triangulate it.

一旦你的点云是显而易见的，无噪音，你就可以运行它三角啮合步骤。

an analysis of the meshing pitch point of a pair of gears by the differential equation of conjugating tooth profile

由共轭齿廓的微分方程分析齿轮的啮合节点

These formulae are suitable for any contacting point of tooth surface meshing.

这些公式适用于齿面啮合的任何接触点.

In this article the bearing ability test of hard gear face point-line meshing gear transmission and the trial of noise test are introduced.

本文介绍了硬齿面点线啮合齿轮传动的承载能力试验和噪声测定试验的情况。

The analysis of corrosive pitting about the points-line meshing gear

点线啮合齿轮点蚀的失效分析

Having found out the transition point on the gear slotting cutter, the authors discuss several cases of interference when the internal meshing gears are slotted and give the checking formulae.

本文在确定了插齿刀过渡点的基础上，讨论内齿轮副插齿加工时的几种干涉情况，并给出了校验公式。

The QX straight conjugate internal gear pump is a new type of hydraulically driving element. The calculation of tooth profile, the limiting point of meshing, the designing process of slotting cutter were introduced.

介绍了一种新型液压动力元件&QX型直线共轭内啮合齿轮泵的齿廓曲线计算、专用插齿刀具设计方法，分析了齿廓啮合极限点。

The relatively velocity's computing formulas of this new spatial cam sliding tooth precision transmission meshing joggle's each contacting point are deduced, and the data computing are accomplished.

推导了新型空间凸轮活齿精密传动啮合副各接触点相对速度的计算公式，并进行了数值计算。