method of surface of section的例句大全

The field test using geological drilling, the electrical sounding method and the transient surface wave three means to evaluation the grouting quality of Xiang-Gui railway expansion and reconstruction project in Guilin test section.

现场试验则采用地质钻探、电测深法和瞬态面波法三种手段分析评价湘桂铁路扩能改造工程桂林测试段的注浆质量。

According to the geometrical data of a three-dimensional model, finish machining strategy with section plane method is adopted on the basis of the offset surface.

根据三维造型数据，采用基于等距面的截平面法进行精加工。

Takes the screw type compressor rotor as an example, a calculating method of unknown section profile of spiral surface and its conjugate shape is introduced and practical formulas are given.

以螺杆压缩机转子为例，介绍了未知螺旋面端截面轮廓及其啮合的共轭齿形求法，给出了实用计算公式。

using the calculation of a cross section curve of varied radius hemicycle groove as an example, a data processing method for nc machining of many special grooves surface is discussed in this paper.

以变半径半圆槽曲面的截面线的计算为例，给出了一类特殊槽曲面数控加工时的数据处理方法。

The method is able to detect the danger section exactly and reflect the skid resistance of a road surface definitely.

该方法能够准确地指明危险路段，更加客观地反映路面实际抗滑能力状况。

a mach number flutter trend of a typical airfoil section with a control surface is analyzed and the results obtained agree well with those with cfd/ csd direct coupling method.

分析了典型三自由度二元机翼的颤振边界，分析结果与CFD/CSD直接耦合方法吻合。

Probe into the Construction Method of Inclined Shaft on Sand and Gravel Aquifer in Surface Soil Section

蓝田、长安人工林地土层含水量研究表土段沙砾含水层斜井施工方法探索

Secondly, in the FEA simulation, matching section line of before and after springback will be gained by 2D section method and then compensation surface will be gained by SGD algorithm.

其次，研究了在有限元分析中，先利用二维截面法得到回弹前后匹配线，再通过SGD算法得到回弹补偿型面。

application of light-section method to roughness measurement on dynamic surface

光切法在动态表面粗糙度检测中的应用

application of light section method to real-time roughness measurement of moving surface

光切法在运动表面形貌在线测量中的应用

Surface model and internal model of orebody were established by line-frame and block-section method, respectively.

基于线框法及块段法分别构建矿体的表面模型及内部模型.

INQUIRY INTO DEFORMATION OF THE AXIAL SECTION IN CROSS ROLLING WITH HELICAL GROOVES AND INVESTIGATION OF ITS EXPERIMENT IN MOIRE METHOD Research on NC Grinding of Rotary Surface Parts with Arc Axial Section and Precision Controlling

螺旋孔型斜轧轴向断面变形的探讨及云纹实验研究圆弧轴截形回转面的磨削及精度控制方法的研究