mm的例句大全

Results It was found that 4~ 15 or more fine perforators derived from each the terminal end of the brachial artery and radial or ulnar arteries in anterior antebrachial region, and their diameters were between 0.2~ 0.9 mm.

结果肱动脉末段和前臂的桡、尺动脉分别发出多达4～15支细小穿动脉，其外径在0.2～0.9mm之间。

The process and parameters of separating terpineol mixture were studied in a batch distillation column of 22 mm in diameter.

通过间歇精馏小试实验，探索了精制松油醇混合物的具体过程及参数。

A dual-box system, consisting of a feeder box, located at up-slope, and a test box, located at down-slope was used to quantify impacts of runoff and sediment from up-slope on rill hydraulic parameters under different rainfall intensities of 50,90 and 130 mm/ h.

利用供沙土槽和细沟土槽双土槽径流小区系统，定量分析了粘黄土陡坡地在50、90和130mmh降雨强度下上方来水来沙对坡下方细沟水流水力学参数变化的影响。

A fretting test of overhead electrical conductor was performed on a conductor bending fatigue test system under the conditions of an axial load of 30 MPa, a frequency of 10 Hz and a bending amplitude of 0.8mm.

在轴向静载荷为30MPa，振动频率为10Hz，弯曲振幅为08mm的试验条件下，在弯曲疲劳试验装置上对JL/G1A12526/7架空导线进行微动试验。

Results Test duration, time to 1 mm ST depression ( STD), double product at 1 mm STD, recovery to 1 mm STD, total ischemic time and max STD may be the parameters of IP.

结果运动时间、ST段压低1mm时间、ST段压低1mm时双乘积、ST段恢复至1mm时间、总缺血时间及ST段压低最大值可作为反映IP的参数。

The performance of switch gap varying from 0.15 mm to 0.40 mm was studied and an automatic test platform for long duration life time testing was designed.

设计了长寿命实验的自动测试实验台，并进行1500次的开关循环实验，证明此装置的可靠性。

Through production field test, the length measurement scope is 6 to 15 meter, and length measurement precision is ± 1 mm.

经生产现场检验，该系统测长范围为6～15m，测长精度为±1mm。

The p-type single crystalline Si wafers were used as substrates and CH4 and H_2 as gas resource, the pressure in the reaction chamber was kept at about 7 Torr and the filament temperature at 2200 ℃, the distance between substrate and filament was 7 mm.

生长纳米金刚石膜所用的硅衬底为p型单晶硅，气源为CH4和H2，石英管生长室内的气压控制在7Torr左右，钨丝的温度为2200℃左右，衬底与钨丝间距为7mm。

Third, add to a small copper bolt on the inner measurement tube's glass wall above 5~ 10 mm the liquid surface in which Beckmann Thermometer's mercury bulb was immerged.

三是在浸没贝克曼温度计水银球的液面上方5~10mm处的常规内测玻璃壁上添加一个小铜螺栓。

Meanwhile, those of the black PEEK composite were 0 21 and 0 61 × 10-6 mm 3/ ( N · m) respectively The wear of the black PEEK composite was controlled mostly by adhesive mechanism and going with thermoplastic flow

黑色PEEK复合材料的摩擦系数为021，比磨损率为061×10-6mm3/（N·m），两种复合材料主要受粘着磨损机制控制，并伴有热塑性流动磨损

As a result, 15 W output power at 1.03 μ m with a slope efficiency over 40% from a 0.35 mm thick Yb ∶ YAG disk laser is obtained.

用0.35mm厚的Yb∶YAG薄片获得15.9W的1.03μm激光输出，斜率效率超过40%。

In embedment group, a thick needle was acupunctured 70 mm and embedded at Tanzhong point for 4 hours.

粗针埋针治疗组选用粗针针刺膻中穴，每次进针70mm，留针4h；

Thickness control system for 2300 mm plate mill

2300mm中板轧机厚控系统

Results The average value of the thickness of the epidural fat was 4.14 ± 1.99 mm. There was no significant difference between male and female.

结果156例成人该水平脂肪厚度平均为414±199mm，男女间差异无显著意义，该值与体重呈正相关。

The diameter of FRP cable protective pipes varies from 50 to 200 mm and the thickness of the pipe wall is from 2 to 12 mm.

玻璃钢电缆保护管直径d为（50~200）mm，管子壁厚t为（2~12）mm，变化范围很大。

The reasonable thickness of the thin slab is from 40 to 60 mm, it will be expected to reach 30 to 50 mm in the future.

薄坯的合理厚度为40～60mm，将来可望为30～50mm；

Results Clear transrectal sonograms of the bladder neck from were obtained from all the cases. Typical sonogram features of bladder neck obstruction were anterior or posterior labium thickened, and projected into the bladder, the thickness range from 4 to 10 mm.

结果所有受检者经直肠超声均可获得膀胱颈连续清晰的图像，女性膀胱颈梗阻超声表现为膀胱颈前唇和（或）后唇增厚突入膀胱，厚度范围4~10mm；

Middle-frequency melting, deformed process and final heat-treatment were used to prepare Pd-Ba alloy foil with thickness in range of 0.1~ 0.2 mm.

经过中频炉熔炼，压力加工以及热处理，制备了厚度尺寸范围0.10~0.20mm的Pd-Ba合金箔材。

The results reveal that 1 mm thickness scale will cause about 60 ℃ increase on the hot surface of cooling stave.

结果表明，水垢每增加1mm厚，会使冷却壁热面温度升高约60℃。

The resultant thickness tolerance of cement lining, after measuring, is not larger than 2 mm by using the new unit.

采用这种挤涂器施工的水泥砂浆衬里，经检测，厚度偏差不超过2mm。