optical thickness的例句大全

error analysis of dielectric optical multilayer variation of sensitivity factor with layer thickness

多层介质光学膜系的误差分析&膜层厚度变化的灵敏度因子

layer thickness control: a metallizer closed-loop function for high quality optical media

溅镀膜厚控制：高质量光盘溅镀闭环功能

optical interferometry for thickness measurement of opaque thin films and the influence of step fabrication

不透明薄膜厚度的光干涉法测量以及台阶的影响

These devices have optical waveguide structure, moderate doping level and active layer thickness.

该器件带有光波导结构并具有适当掺杂和有源层厚度.

Methods: The anterior chamber depth and corneal thickness in seventeen patients ( 32 eyes) with angle closure glaucoma were measured by UBM ( Zeiss Humphrey 840, Germany) and optical instruments ( Haag Streit, Depth Measuring Devices ⅰ+ ⅱ, Swiss), respectively.

方法：应用德国产Zeiss-Humphrey840UBM、瑞士产Haag-Streit前房深度计及角膜厚度计测量闭角型青光眼17例（32只眼）的前房深度和角膜厚度并进行统计分析。

Based on the measurement method on optical film refractive index and thickness, commonly used in the world, a method which derived from variable angle spectroscopic ellipsometry is used to set the primary standard of optical film refractive index and thickness for national defense.

论文在综合了国际上光学薄膜折射率和厚度不同测试方法的基础上，采用可变角椭圆偏振法来实现和建立国防系统的光学薄膜折射率和厚度最高标准。

The main parameters about plane optical waveguides include refractive index and membrane thickness.

平面光波导的主要特性参数是波导的折射率n和厚度w，决定这些参数的方法有许多种，我们采用棱镜&薄膜耦合器法来测量这些参数。

Optical coherence tomography in measuring retinal nerve fiber layer thickness in pituitary tumor

应用光学相干断层扫描仪检测垂体瘤患者视网膜神经纤维层厚度

This paper introduces the methods of target thickness and uniformity measurements including weighing, a-particle thickness gauge, quartz thickness gauge, optical transmittance and Rutherford backscattering.

本文系统地介绍了核靶厚度和均匀性的测量方法，包括天平称重法、石英晶体测厚法，等效空气α粒子能量损失法，吸光光度法和离子背散射法。

Analysis of serial optical sections using confocal laser scanning microscope allow measurement of the thickness of each layer of amnion.

2通过共聚焦激光扫描连续光学切片可以计算出羊膜各层的厚度；

The weight, thickness, hardness, surface morphology, composition and wearing resistance of Ni-Co-P/ Si3N4 coating have been measured by analytical balance, optical microscope, microhardness, SEM, EDS and abrasion testing machine.

利用分析天平、金相显微镜、显微硬度计、扫描电镜、能普仪和磨损试验机，对镀层的重量、厚度、硬度、表面形貌、成分和耐磨性进行检测。

Objective To evaluate the accuracy of measuring central corneal thickness by Optical coherence tomography ( SL-OCT) in LASIK.

目的探讨眼前节相干光断层成像（OCT）在LASIK术前角膜厚度测量的精确性。

The incision depth is larger than the cladding thickness but smaller than the optical fiber radius.

切口深度大于包层的厚度而小于光纤的半径.

Using the data acquisition system combined optical measuring device, the thickness of the standard block gauge and the oil film was measured, and the experimental results were analyzed.

利用该数据采集系统结合光学测量装置，对标准块规和石油油膜进行了数据采集实验，并对实验结果进行了分析。

Used for measuring the thickness and optical constants of transparent or semi-transparent single film or multilayer.

单层 或多层薄膜的厚度和光学常数的测定.

The films with thickness of nanometers have wide applications in the fields of microelectronics, materials and chemical engineering, optical and laser technology.

纳米级厚度薄膜在微电子、材料与化学工程、光学与激光技术等诸多科学领域有着广泛的应用。

Film thickness uniformity used in area optical film for outdoor lighting is required higher.

户外照明采用大面积光学薄膜,对薄膜均匀性提出较高的要求.

Study on in-line measuring thickness of firebrick by optical fiber sensor

光纤传感器在线检测耐火砖厚度的研究

The technological principle of the unequal thickness hot-pressing of IR optical materials

红外透光多晶材料不等厚压制工艺原理

Test methods for film thickness and optical constants

薄膜厚度和光学常数的主要测试方法