optimal temperature的例句大全

The protection function of imbalance, over speed, over temperature for optimal operating convenience.

设有不平衡、超速、超温多种保护功能，实现最佳运转性能。

A DCS control system was designed for batch pulping process with optimal algorithm in this paper. The kappa value was predicated accurately, and then the temperature set curve was optimized on line by the algorithm.

针对立式蒸煮锅设计了一套基于DCS控制系统的间歇蒸煮过程计算机优化控制系统，实现了对木浆卡伯值的精确预报和升温曲线的在线优化。

the results indicate that there must be optimal operating point of thrust magnetic bearing with massive magnet. the main effecting factors of carrying capacity temperature rise characteristic involve static gap and/ or ampere turns.

结果表明：实心磁铁推力磁轴承存在最佳工作点，影响轴承承载力温升特性的主要因素是静态气隙和绕组安匝数，且对静态气隙更敏感。

the optimal conditions were obtained as the mass ratio of epoxy chloropropane to straw alkaline lignin 12 ∶ 1, the volume of naoh ( 20% by weight) 5 ml, the reaction temperature 80 ℃, and the reaction time 3 h.

单因素试验结果得出合成环氧树脂的条件为：环氧氯丙烷与碱木质素的质量比为12∶1，每克木质素用氢氧化钠（质量分数20%）5mL，反应温度80℃，反应时间3h。

the relationship of temperature measurement accuracy with process tolerance is simulated quantitatively by spice, and the optimal design for this circuit is given.

借助于SPICE程序，进一步对温度测量精度与制造工艺容差的关系进行定量模拟，为电路的优化设计提供了依据。

the optimal technical conditions for nsp addition were determined by experiment as follows: 1% addition quantity, addition temperature at 45 ℃, and action time as 20 min. ( tran. by yue yang)

试验确定NSP酶添加的最佳工艺条件为：添加量1.00%，添加温度45℃，作用时间为20min。

the equipment parameters and drying technique conditions of drying box for lyophilizing granula were established by the exploration to optimal drying temperature and highest permitted water-content of vitamin c effervescent tablet.

通过考察维生素C泡腾片颗粒的最佳干燥温度和最高容许含水量，确定了冷冻除湿颗粒干燥箱的设备参数及干燥工艺条件。

the optimal activating conditions obtained were: activating time 1 min, activating temperature 60 ℃.

实验确定了适宜的活化条件：活化时间1min，活化温度60℃。

the results indicate that: temperature 20 ℃-30 ℃, initial seeding dosage 2%, and ph 8-9 are the optimal conditions for s6 to produce surfactant.

研究结果表明：S6菌株的最适培养温度为20℃～30℃；最佳初始接种量为2%最佳初始pH为8-9；

the effects of h 2o 2 concentration, reaction time, temperature and ph on the bleaching effects of dietary fiber were investigated using hydrogen peroxide as bleaching reagent. the optimal conditions for bleaching were confirmed through orthogonal test.

以H2O2为漂白剂，探讨了H2O2用量、反应时间、反应温度和pH对三种葛根膳食纤维（DF）漂白效果的影响，并用正交试验确定了葛根膳食纤维漂白的最佳工艺条件。

after orthogonal experiment, the optimal parameters of improvement of soy lecithin color were: addition of 3.5 percent of hydrogen peroxide, addition of 0.6 percent of benzoyl peroxide, reaction temperature 65 ℃ and reaction time 1 hour.

通过正交试验，得到改善大豆浓缩磷脂色泽的最佳条件是：双氧水的加入量为3.5%、过氧化苯甲酰的加入量为0.6%、反应温度65℃、反应时间1h。

this paper concerns the optimal standard of temperature during the reaction process and investigates the rate-determining step in the reaction process.

本文研究了反应过程的最优温度规范，并探讨反应过程的控制步骤。

It proposes optimal algorithm numerical simulation to the temperature distributing of part of Arctic sea.

并且提出了优化算法,模拟了部分北极海域的温度分布状况.

Based on principles of thermochemistry and under conditions of given equilibrium components are calculated the highest temperatures attainable when RDX and aluminiferous RDX are detonated The relationship between the aluminium content and the detonation temperature is discussed The optimal content of aluminium for different application purposes is suggested

在已知平衡组分的条件下，用热化学计算基本原理计算了RDX及含铝RDX爆炸时所能达到的最高温度，讨论了含铝量和爆炸温度的变化规律，给出了满足不同用途的最佳含铝量

We try to approximate the operating temperature to the optimal value.

我们努力使工作温度接近最佳值。

The Thermodynamic Principle and Formula for Determining the Optimal Boiling Temperature in Low Temperature Waste Heat Power Recovery System

低温余热动力回收系统中确定最佳蒸发温度的热力学原则和计算式

The optimal conditions were found to be the molar ratio of benzyl chloride to OH group in bamboo 3, reaction temperature 80 ℃, and reaction time 2 h. It was found that the crystalline structure of the native ball-milled bamboo was damaged after benzylation modification.

适宜条件为：氯化苄对竹粉羟基的摩尔比3，反应温度80℃，时间2h。原本球磨竹粉在苄基化改性后结晶结构发生了破坏。

The result showed that the optimal carbon source and nitrogen source was corn flour and bean cake flour, respectively, and pH 5 and 26 ℃ was the optimally initial pH and temperature, respectively.

结果表明血芝液体发酵的最适碳源为玉米粉，最适氮源为黄豆饼粉，最适初始pH值为5，最适温度为26℃。

The effect of semi-rigid base layer conditioning period, high penetration emulsified asphalt spread temperature and conditioning temperature to the penetration effect were also analyzed. Furthermore, the shear strength test between surface and base layers were utilized to obtain the optimal content of high penetration emulsified asphalt.

并分析了基层养生龄期、高渗透乳化沥青洒布温度、养生温度等因素对渗透效果的影响。其次，进行了基层与面层间抗剪强度试验，得到了高渗透乳化沥青最佳用量。

The optimal reaction conditions were determined: the concentration of hydrochloric acid was 3%, boiling time was 4 h, calcination temperature was 550 ℃.

对新方法制备白炭黑的工艺条件进行了研究，确定了反应的最佳工艺条件：盐酸质量分数为3%，煮沸时间为4h，煅烧温度为550℃。