order of element的例句大全

order of element in group

群元素的阶

and the order of element concentration was first n, next k, then ca, p, mg, fe, mn, zn and cu in order.

在元素含量的顺序上是氮最高，钾次之，随后依次为钙、磷、镁、铁、锰、锌、铜。

The convergence of tetrahedral isoparametric element is analysed in this paper, and the optimal H~ 1 error estimate is obtained, then it is used to solve 3-dimensional 2-order homogeneous Dirichlet problem on surface domain.

本文的主要内容是讨论了四面体等参元，分析了其收敛性并给出了最优H~1误差估计，并把它应用到曲面区域的三维2阶齐次Dirichlet问题。

In order to ensure the temperature stabilization of each sensitive element on the focal plane, a high performance and accuracy temperature control system is designed.

为了保证焦平面上各敏感元的温度稳定性，设计了一个高性能、高精度的温度控制系统。

In order to ISO-834 standard temperature-time to curve simulated fire ( high temperature), temperature calculation and mechanical analysis using the three-dimensional coupled thermo-mechanical unit of the large-scale finite element analysis software ANSYS.

以ISO-834标准温度&时间曲线模拟火灾（高温），采用大型有限元分析软件ANSYS中的三维热力耦合单元进行温度计算和力学分析。

In order to calibrate the finite element lattice nodes of tolerances efficiently, an effective direct measure approach is developed in this article, which is fulfilled by laser interferometer to measure the terminal error of machine tool directly.

为了高效标定误差有限元网格节点参数，提出了用跟踪激光干涉仪实现机床误差的直接测量方法。

In order to improve the accuracy of simulation in the case of large deformation of tissue, we developed a total Lagrange finite element tissue deformation simulate method and update Lagrange finite element tissue deformation simulate method.

在大形变条件下组织形变精确仿真方面，本文提出了完全拉格朗日格式下的粘弹性有限元组织形变仿真算法和更新拉格朗日格式下的粘弹性有限元组织形变仿真算法。

Convergence of Space-time discontinuous finite element of one-order hyperbolic systems

一阶双曲型方程组的时空间断全离散有限元的收敛性

And Abelian group and non-Abelian group. The order of an element is a significant concept in group.

而元的阶又是群的一个重要概念，元的阶和群的阶有着内在的联系；

In order to calculate the pipeline's allowed minimum residual wall thickness, the text takes it as the research object, utilizes the finite element software of ANSYS, sets up finite element models, carry on non-linear finite element analysis, thus received its concrete number value.

本文以在役腐蚀缺陷管道的最小允许剩余壁厚为研究对象，利用ANSYS有限元分析软件，建立有限元模型，进行非线性有限元分析，从而得到其具体数值。

The heat load to the vacuum vessel thermal shield ( VVTS) is analyzed by FLUENT finite element software in order to demonstrate that the design of cooling tubes is reliable.

采取有限元法对内冷屏的受热状况进行了计算分析，以验证内冷屏氦冷却管道设计方案的可靠性。

An Introduction to Higher Order Super-Element for Analysis of Shear Walls

介绍一种剪力墙结构分析的高阶开孔单元

Studying the stress distribution of the spiral case, reinforcement and cracking development of surrounding concrete by means of 3-D non-linear finite element analysis, in order to obtain a feasible reinforcement amount and arrangement.

根据选定的充水保压值，对蜗壳和外围钢筋混凝土进行非线性分析，对外围混凝土裂缝发展、蜗壳和钢筋的应力分布进行研究，确定合理的混凝土配筋参数；

In order to make the structural design optimization, respectively, wall thickness and the blade thickness to optimize the targeting and minimization of the optimum design in order to get the optimal design. Third, to analyse the dynamic characteristics of spiral roller finite element.

为使设计最优化，分别以管壁厚度和叶片厚度为优化目标，进行强度减量化的优化设计，得出最优设计方案。然后，利用有限元分析对螺旋滚筒的动态特性进行校核。

For each fourth order parabolic equations, the mixed discontinuous space-time finite element scheme is constructed by lowering the order of the equation by mixed finite element. And the equation is discretized by space-time finite element method, continuous in space but discontinuous in time.

对每个方程构造了混合时间间断时空有限元格式，利用混合有限元方法将高阶方程降阶，利用空间连续而时间允许间断的时空有限元方法离散方程。

Then, using the second-order central difference to discretize the time derivative of the displacement, and applying the quadrature formula to the mass matrix, a fully discrete lumped mass Morley element method is developed for the same problem.

然后利用中心差分格式离散时间方向的二阶导数，再利用适当的求积公式得到薄板弯曲问题的集中质量Morley元全离散格式。

In chapter two, the coupling equation of finite element and boundary integral methods is applied to a class of three-order nonlinear wave equation with exterior domain.

第二部分应用自然边界元与有限元耦合法处理一类非线性波动方程的外边值问题。

In this paper, a high-order approximate artificial boundary condition of Poisson equation with an exterior domain is investigated, and the error estimates for the solution of finite element approximation, which is based on the approximate artificial boundary condition, are given.

研究泊松方程外区域问题的高阶近似人工边界条件，并给出了利用此人工边界条件时有限元逼近的误差估计式。

The strength of sliding piece and shaft of rotating wheel body were calculated by finite element method in order to validate the designing veracity.

应用有限元方法对滑片和转轮体轴等的强度进行了计算，以验证设计的准确性；

Pillar works as the mostly important element of framework, which going through the whole history, such as stone pillar in Egypt, totem pole of Africa, wood class pillar in China, class order of Europe, steel pillar and reinforced concrete pillar in modern period.

柱子作为柱梁结构的主要构件，贯穿整个历史时期，如埃及石柱、非洲图腾柱、中国木柱、欧洲古典柱式、现代的钢柱和钢筋混凝土柱。