output beam的例句大全

admittedly, the energy needed to produce a cepheid-modulating neutrino beam really would be a sizeable fraction of the output of the sun.

应当承认，制造用来调整“造父变星”的中微子束所需要的能量确实将相当于太阳整体输出能量的大部分份额。

The beam propagation method ( BPM ) is used to simulate and optimize the design and input-output characteristics.

应用光束传播法给出了弧形波导全光开关的输入、输出开关特性以及优化设计结果.

Please have the three-phase rectifier checked for the output wave with a dual beam synchroscope.

请用双线同步示波器检查 三相 整流器的输出波形.

Analyses have been made on the principal aspects of high pressure CO2 laser. Several modern preionization techniques have been assessed. In order to develop a high-pressure CO2 laser of high energy output and large beam cross section, the X-ray preionization techniques are more potent.

对高气压CO2激光器的基本情况作了分析，评价了几种现代常用的预电离技术，认为在发展大能量、大束截面的高气压CO2激光器中x光预电离技术是较有潜力的。

But beam quality of slow axis is easily affected by space burned hole, self-focusing and thermal lens effect, which lead to big slow axis divergent angle under high output power.

然而由于其慢轴方向输出光束质量极易受到空间烧孔、自聚焦、热透镜等效应的影响，致使其在高功率工作条件下，输出的慢轴方向发散角较大。

More than 400 mJ, 40 Hz output laser with near diffraction limited beam quality was obtained.

最终获得了重复频率40Hz、单脉冲能量大于400mJ、近衍射极限的高光束质量激光输出。

Theoretical Design and Output Signal Analysis of the Circular-section I-shaped Beam Shearing Force Sensor

圆截面工字梁剪力传感器理论设计与输出信号分析

anamorphic prism pairs are designed to expand a beam in only one dimension, circularizing the elliptical output from a diode.

变形棱镜组可用来扩散一个方向的光束，可将激光二极管发出的椭圆光进行圆整。

The results prove that several hundred fiber laser beams combination could be realized through incoherent beam combination methods, and the output power would reach the level of 10 kilowatt in contrast to 10 fiber laser through coherent combination method.

结果表明，非相干组束方法可以实现几百根光纤激光的合成，组束功率可以达到10kW量级，而相干组束方法只能实现大约10根光纤激光的合成。

The method of improving unit output at roof clasping coal face with π type steel beam

提高π型钢梁放顶煤工作面单产的途径

As the development of Inertial Fusion Energy ( IFE), the laser output with high energy and high light beam quality while work at high repetition is needed.

为了满足惯性聚变能源（IFE）的要求，激光驱动器必须以较高的重复频率输出高能量、高光束质量的激光。

The pigtail output power of single mode polarization maintaining fiber reached ( 1.5 mW) due to lower vertical beam divergence.

由于器件具有比较小的发散角，与光纤耦合时具有比较高的耦合效率，单模保偏光纤耦合输出功率达到1.5mW。

Steady Si beam can easily be obtained at a constant power output.

电子束蒸发器的性能试验表明，稳定输出功率可以控制输出稳定的Si束流。

Automatic compensation for temperature drift of deflecting output of e beam system

电子束偏放输出温度漂移的自动补偿

Slab laser, especially diode-laser partially-end-pumped slab laser ( InnoSlab), is one of the most efficient ways to generate powerful laser output with excellent beam quality because of predominant thermal conduction.

板条激光器，尤其是半导体激光列阵部分端面泵浦混合腔板条激光器（InnoSlab），由于导热性好，容易得到大功率高光束质量的激光输出。

In addition, analytic expression of the waist spot size and working distance of output Gaussian beam were derived, and the influence of coreless fiber and GRIN fiber ′ s length upon fiber-lens parameter was discussed by numerical simulation results.

推导了出射高斯光束的束腰半径和工作距离的解析表达式，进而对该光纤透镜做了数值模拟，讨论了无芯光纤和GRIN多模光纤的长度对光纤透镜参数的影响。

Energy spread and ( b) different match condition between electron beam and optical beam, and 3. nonideal incidence of e-beam beyond some region causes the exponential reduction of output power.

非理想入射（偏入射和斜入射）超出一定范围之后将引起输出功率的指数下降。

Uniform pumping and uniform cooling are key techniques to reduce thermo-optical distortion and to achieve high beam quality output for solid-state laser.

均匀抽运及均匀冷却是激光二极管抽运激光器减小热致光学畸变以实现高光束质量输出的核心技术难题。

on the basis of kinematic analysis, the power equations of kinetic energy theorem are introduced to calculate the influence of each part of the beam pumping unit on the output axle torque of crank respectively, and the expressions for solving the crank output axle torque are derived.

在此运动分析的基础上，应用动能定理的功率方程，分别考虑游梁式抽油机各部件对曲柄输出轴扭矩的影响，得到求解曲柄输出轴扭矩的表达式。