penetration test的例句大全

protective helmets - test methods - part 3 : resistance to penetration.

防护头盔.试验方法.第3部分：抗穿透性

protective clothing for use against liquid chemicals - test method: determination of resistance to penetration by spray (spray test)

液态化学品防护服试验方法：喷射抗渗透性的测定（喷射试验）

protective gloves against chemicals and micro-organisms; part 4: determination of resistance to penetration; air leak test

抗化学药品和微生物的防护手套第4部分：耐渗透的测定漏气试验

The effect of semi-rigid base layer conditioning period, high penetration emulsified asphalt spread temperature and conditioning temperature to the penetration effect were also analyzed. Furthermore, the shear strength test between surface and base layers were utilized to obtain the optimal content of high penetration emulsified asphalt.

并分析了基层养生龄期、高渗透乳化沥青洒布温度、养生温度等因素对渗透效果的影响。其次，进行了基层与面层间抗剪强度试验，得到了高渗透乳化沥青最佳用量。

test and research on triple row tube high pressure jet grouting to build water penetration proof wall

三列管高压喷射灌浆构筑防渗墙的试验研究

hot applied joint sealants - test method for the determination of heat resistance - change in penetration value

热用密封胶.耐热性测定的试验方法.穿透值的变化

hot applied joint sealants - part 4: test method for the determination of heat resistance; change in penetration value

热接合密封剂第4部分：热阻测定的试验方法穿透力值的变化

Test Validation of Hole Expansion Effect During Penetration of Pile

成桩挤土效应实验验证

Welding test of the products has shown that penetration of the lap weld can be controlled in required tolerance for design using the control system.

产品焊接试验表明它可以使搭接焊缝熔深控制在产品设计要求的范围之内。

graduation and test methods of air permeability and water penetration for building external doors

GB/T13686-1992建筑外门的空气渗透性能和雨水渗漏性能分级及其检测方法

Based on test results, a computation model is proposed for researching the compaction effects of open-ended pipe piles. This model simulates the pile penetration as the expansions of a series of spherical cavities in semi-infinite space.

基于试验结果，建立了开口管桩挤土效应解析计算模型，将桩体的压入过程模拟为半无限体中一系列球孔的扩张。

Salt solution and then placed in a special specimen damage, into the freezing and thawing the freeze-thaw cycle test cases, test cycles under different concentrations of chloride ion penetration and the concrete surface erosion situation.

然后将盐溶液置于特制的损伤试件中，进冻融箱进行冻融循环试验，测试不同循环次数下氯离子渗入的浓度以及混凝土表面的剥蚀情况。

By the penetration and ballistic test for different state nitrogen alloyed austenitic steels and low alloyed martensite steel, their penetration mechanism was analysed.

对不同状态含氮奥氏体钢板和马氏体钢板进行了抗枪弹与抗杆式模拟弹试验，分析了它们的穿甲机理。

the penetration process is similar to vickers hardness test.

弹体的侵彻过程与压入法测硬度相似。

Contrast Test of Reinforcement Penetration Method and Ring Sampler Method for Sand Filling Compactness

填砂密实度的钢筋贯入法与环刀法对比试验

Finally, analyze the change of system reliability indices after integration of wind power base on multi-state UGF model by IEEE-RBTS test system. To calculate the maximum wind power penetration and spinning reserved capacity base on a specific reliability standard.

最后，按照多状态UGF模型，通过IEEE-RBTS算例分析了风电并网前后系统可靠性指标的变化，计算了基于既定可靠性的区域电网风电最大消纳量和备用容量的大小。

The test involves penetration of the womb, and carries a risk of inducing miscarriage.

这个测试需要穿刺子宫, 因此具有引发流产的风险.

An in vitro skin penetration and absorption test was made using thin layer scanning method to determine the active component tetrahydropalmatine in the Asthma Plaster to find out the effect of different concentrations of azone on the skin penetration and absorption of the Asthma Plaster.

应用改进的Franz扩散小池进行体外透皮吸收试验，采用薄层扫描法测定定喘膏中活性成分延胡索乙素的含量，研究不同浓度的氮酮对定喘膏透皮吸收的影响。

On the basis of having success, such a test for raising penetration rate and reducing comprehensive drilling cost was also carried out in two small diameter holes, and a good result was achieved.

在成功试验的基础上，开展了2口提高钻井速度、降低钻井综合成本的小井眼天然气欠平衡钻井试验，取得了较好的应用效果。

Based on that, the simulation test of stud penetration welding was designed.

在此基础之上，设计了栓钉穿透焊模拟试验。