point gear的例句大全

active design method of spiral bevel gear was improved by considering alignment error sensitivity of calculating point.

考虑初始计算点误差敏感性，改进了螺旋锥齿轮主动设计方法，通过计算选择安装误差敏感系数较低的初始计算点，达到减小设计齿轮副误差敏感性的目的。

Before the three-point landing gear wheel.

前三点轮式起落架.

After the point landing gear to the cockpit for the whole open.

起落架为后三点式,驾驶员座舱为全开放式.

At this point you should replace the freighter or to change gear engaged.

此时答调换货轮或保持齿轮的啮合场所.

The analysis of corrosive pitting about the points-line meshing gear

点线啮合齿轮点蚀的失效分析

The general electroplating CBN honer surface is point contact engagement with the gear surface in the process of cutting, thus the cutting efficiency is low and the CBN abrasive is wasted.

珩齿加工过程中，普通电镀CBN珩磨轮的齿面与被加工齿轮齿面是点接触啮合，因而加工效率低且造成CBN磨粒的浪费。

The mechanism is made up of gear and gear rack can get rid of dead point.

提出了一种齿轮齿条机构产生匀速往复直线运动并能克服死点的方法.

The guiding gear's line must be vertical with the central point of the roller's central line.

起重机的导向轮中心线必须垂直于卷扬机卷筒中心轴线的中心点.

In this article the bearing ability test of hard gear face point-line meshing gear transmission and the trial of noise test are introduced.

本文介绍了硬齿面点线啮合齿轮传动的承载能力试验和噪声测定试验的情况。

The ratio is determined by the distances from the center of the gear to the point of contact.

传动比是由两轮的中心到啮合点的距离所决定的。

This paper describes the performance test, contact fatigue strength test and bending fatigue strength test on the gear reducer of involute point contact Ferrographical analysis is made.

本文对渐开线点啮合齿轮减速器进行了性能试验、接触疲劳强度和弯曲疲劳强度试验，同时还进行了铁谱分析。

The former takes the minimum fuel consumption rate point in the whole engine operating range as the target, the throttle opening keeps constant, the gear ratio of CVT is adjusted by the controller which is a single parameter control system.

单纯经济型作业模式以发动机在整个工作范围内的最低燃油消耗率点为目标工作点，油门开度不变，仅控制变速器传动比，为单变量控制系统；

Changing the drive of timing mechanism from timing gear to notched belt can greatly reduce the high and medium frequency ( higher than 500 Hz) radiated noise at front measuring point of the engine.

而将正时机构由正时齿轮传动改为同步齿形带传动，可以大大改善前端测点的500Hz以上中、高频辐射噪声。