point load的例句大全

An approximate solution on ultimate load of a circular plate under radial and lateral loads is derived from equations by subdomain Weighted Residual Method ( WRM) and point by point WRM.

本文应用加权余量法中的子域法和配点法，求出了均匀圆板在径向和横向均布荷裁作用下的极限荷载的近似解。

Firstly, the bending load-deflection relationship and failure modes of the test specimen were obtained by the four-point bending test.

首先进行静态四点弯曲实验，得到实验试件在静态弯曲载荷作用下弯曲载荷与加载点挠度的关系以及试件在静载作用下的破坏模式。

Finally, it is verified from the point on view of the queuing theory that the average response time of system can remarkably be reduced by using semantics-based load balancing system.

最后，从排队论观点证明了基于语义的负载均衡系统能显著降低系统的平均响应时间。

Based on the differences of harmonic testing point, there are two control ways for shunt active filters, that is, the way of load current sensing and the way of power supply current sensing.

并联型有源滤波器根据其谐波检测点的不同，有两种控制方法.即负载电流检测控制方法和电源电流检测控制方法。

In order to verify the analysis results, static test on two spatial full-sized solid models is carried out, and the step-by-step load apply system is adopted to find out the stress and strain value of each testing point.

为验证计算分析结果，对两个受力较大的铸钢节点进行了足尺实体静力试验，采用分级加卸载制度获取各级荷载下各观测点应力应变值。

According to the analysis of experimental data, based on the theoretical model of composite, we can get a theoretical tensile curve of specimen and the theoretical deflection curves on 3-point bending load bending, then compared them with experimental data respectively.

分析实验数据，并根据复合材料理论分析模型，得出试件理论拉伸曲线和三点弯曲载荷下的理论挠曲线，分别与实验数据进行比较。

It was pointed out that in tensile test with specimen of C-grade casting steel, the load-halt method or the judgment from the pointer swing of strain instrument could not give clearly the yield point except the graphical analysis method.

指出测定C级钢拉伸试样屈服点时，用载荷停顿法或指针法，屈服现象不明显，只有图解法可一次测出未知屈服指标。

The results show that the point contact and line contact friction coefficients of the steel-steel pairs take on declining trend with increasing the test load under dry lubrication.

结果表明，在试验范围内，随着试验负荷的增大，钢-钢摩擦副在干摩擦条件下线接触摩擦因数和点接触摩擦因数呈逐渐下降的趋势，这种下降趋势在线接触时尤为明显；

Having succeeded in building up an exercise model, the three point bending experiment was conducted on the left femur to determine the effects of different training load on bone biomechanics.

在成功建立骨质疏松大鼠运动模型基础上，将大鼠左股骨进行3点弯曲实验，对不同强度运动下的骨生物力学性能变化进行了比较研究。

Simulation of the Damage Progression of Composite Panels Under Three-point Bending Load

复合材料层合板三点弯曲损伤失效数值研究