position switch的例句大全

Position switch into license plate lamp housing and connect switch harness connector.

定位开关到牌照灯壳,连接开关线束接头.

NOTE: THIS IS NOT THE PARK NEUTRAL POSITION SWITCH.

注意: 这不是停空档位置开关.

this provides the basis for an inductive momentary contact switch and an inductive position switching device.

这提供了一个短暂接触感应开关的基础和位置感应开关器件。

A mechanical interlock ensures that the cable compartment cover can only be removed when the three-position switch is in earthed position.

机械联锁保证只有在三位开关处于接地位置时才能揭开电缆室盖。

a charging port is also added to the lower position easy access switch mount.

另外，亦增加了一个充电位在较低和容易接近的开关托架上。

Starting out on your right forearm plank position, bring your left knee to your left elbow, hold for 30 seconds, rest for 30 seconds, then switch sides.

首先做好右前手臂放在平板上的姿势，将左膝盖靠近左手肘，坚持30秒，然后休息30秒，之后换边。

And take use of spiral type of four position automatic switch cutter frame system.

采用螺旋型四工位自动转位刀架系统。

Press "Open" or "Close" button, while reaching stop position, stop switch will be activated and the proscenium curtain machine will stop running.

按下“开启”或“闭合”按纽，幕体到达行程终止位置时，行程终止开关将被激活时，大幕机停止运行。

AB method is much advanced in monitoring the thickness. Through the switch of monitoring glass and appropriate choice of wave length, stop point of each layer was located in sensitive position.

AB法是一种比较先进的监控方法，通过变换监控片和移动监控波长，把每层膜的镀制停点选择在灵敏位置。

In this paper, a pneumatic actuator position servo system is described, which controlled by a five-point switch PWM control method using high-speed switching valves.

本文使用一种五点开关PWM控制算法对高速开关阀控气动执行器进行位置伺服控制。

Design Problem about Position of Pedal Arm from Stoplight Switch

踏板臂与刹车灯开关位置偏离的设计问题

Depending on the switch position and the direction of current to the armature, the appropriate motor will either revolve clock-wise of counterclockwise to produce the desired seat movement.

根据开关的位置与流入电枢时电流的方向，电动机开始顺时针或逆时针旋转从而使座椅根据需要进行调整。

the automation measurement system of the air pump switch is introduced in this paper. the system adjusts position of the pressure spring and establishes the pressure signal of the air pump switch by industrial control computer.

介绍了气泵压力开关的性能参数自动调整测控系统，该系统采用工控机系统控制步进电机来实现对气泵开关压力弹簧位置的调整以及压力信号的设置。

Turn the ignition switch to the LOCK ( 0) position.

转动点火开关到锁（0个）位置。

The test bench equipped with 8031 one-chip computer can be used for the test of ignition switch lock at random times and can tell the operating times, position and number of contact points of the switch when trouble happens;

测试台采用以8031单片机为核心的测试装置，对车锁可作任意次数的测试，并能随时检测出发生故障时的开关次数、档位及触点数；

Turn the ignition switch to the ON ( II) position, and make sure to close the driver's door.

起动点火开关到（ii）位置，并且保证关闭司机的门。

Press the door lock switch to the lock position.

把门锁开关压到锁的位置。

To use frequency variation to regulate the speed of navigation lock gate, reducing the gate crush due to improper position of the position limit switch and enabling the lock gate more stable in speeding up and down.

在船闸闸门调速中采用变频调速，减轻了闸门因限位开关位置不当等原因造成闸门碰撞，使闸门运行中加减速更加平稳。

Protecting two limited directions by one limited switch Regioselective benzylation on the C-2 position of glucose

单只限位开关保护双向极限位置葡萄糖2位羟基选择性苄基化保护

Drain Plug/ Backup Light Switch Location Position bulb in lamp and snap into place.

放油塞/倒车灯开关位置将灯泡固定于灯上并卡入定位。