preload的例句大全

the investigation of global end - diastolic volume as an indicator of cardiac preload in hemorrhaged shock models of dog

全心舒张末容量作为判定心脏前负荷指标在犬失血性休克模型中的研究

experimental measurements related the bias and the preload to the bias repeatability, the width of the blind area, etc.

通过零偏与预载的关系实验，定量分析了零偏不重合度、零偏重复性等，并对实验数据进行误差分析。

if you go to the trouble to preload a set of data, it should be replicated to avoid having to re-load it on a failure.

如果您费力去预加载数据集，应该同时将其复制，以避免出错时需要重新加载它。

the results of test for 08b double-strand roller chain indicate that the best preload is about 2/ 3q ( q is the ultimate tensile load of the tested chain) and it improves the fatigue performance and length accuracy uniformity obviously.

对08B双排链的试验结果表明，经（2/3）Q（Q为链条极限拉伸载荷）预拉后的链条、链长精度均匀性明显改善；

preload analysis of double row angular contact ball bearing

双列角接触球轴承预紧力分析

rigidity calculation of axial position preload taper roller bearings

圆锥滚子轴承轴向定位预紧刚度计算

Uni-Trek adjustable preload with rebound damping.

统一企业迷航与反弹阻尼可调负荷.

A figure is made to show the relationship between preload and fatigue limit of bolts.

为了研究预紧力对螺栓疲劳极限的影响,实验求得了螺栓的疲劳图.

Diminished venous return ( preload ) results in decreased ventricular filling and reduced stroke volume.

静脉回流减少 ( 前负荷 ) 导致心室充盈下降和每搏量减少.

The way to preload pressure and the relationship between preloaded pressure and thrust was studied.

对预压力的施加方式和预压力与推动力之间的关系进行了研究.

The screws are used to apply a compressive preload at the interface between plate and bone.

此时螺钉在钢板-骨界面产生加压预载荷.

If feasible, preferably with rubber spring on the actual preload.

如果可行的话, 最好能在弹簧上加上橡胶件的实际预紧力.

As matched pairs of bearings, preload for them is more convenient.

成对使用时, 以预先调整好间隙的配对角接触球轴承最为方便.

Calcium channel blockers reduce afterload with little effect on preload.

钙通道阻滞剂降低后负荷,而对前负荷几乎没有作用.

Put the preload water into the tank.

向压载舱里灌压载水.

It is necessary to keep the preload constant over the speed range of the spindle.

保存在纱锭的速度范围上的预载常数是必需的.

Determination of preload for the bolted connection under working state of vibration

振动工况下紧螺栓联接预紧力的确定

Under the valve spring preload and seating impact force, the deformation at the site of contact accumulated more and more big, eventually leading to the valve seat fatigue failure.

气门座圈在预紧力和落座冲击力的共同作用下，在接触部位变形累计越来越大，最终导致气门座疲劳破坏。

If you can identify a working set ahead of time and it can fit in the available memory, then the simplest strategy is often to preload the working set.

如果您可以及早识别一个工作集，且它适合可用内存，那么最简单的策略通常就是预加载工作集。

A vibration stimulating and measuring system for SPM is built up. The influence of SPM scanners, probes, samples, tip preload stresses and open/ close loop tip-sample interactions are tested on SPM VRR.

搭建了SPM激振、测振的实验系统，对不同的SPM扫描器、探针、样品、针尖预应力以及针尖-样品副开/闭环对SPM抑振系数的影响进行了实验研究。