pressure jet的例句大全

In this paper, the condition of cleaning 452 processing water pool of 801 reactor by high pressure jet stream was explained.

本文介绍了用高压水射流技术对801反应堆452工艺水池放射性去污的情况。

After the loess tunnel after the foundation treatment has been open to traffic, and is running well, explains the high pressure jet grouting pile foundation reinforced loess tunnel obvious effect, of great economic benefits and social benefits, is worth popularizing widely application.

经过地基处理后的黄土隧道目前已经通车，并运行良好，说明了高压旋喷桩加固黄土隧道地基效果明显，具有很大的经济效益和社会效益，值得广泛推广应用。

Cleaning for Processing Water Pool of 801 Reactor by High Pressure Jet Stream

801反应堆工艺水池高压水射流去污

Study and Application of Outburst Control Technology for High Pressure Water Jet Slotting

高压水射流割缝防突技术研究与应用

A liquid drop removed from a sheet or jet may be exposed to the aerodynamic pressure effect of a high relative gas velocity.

离开液膜或射流的液滴，可能会受到高的相对速度气体的气动压力影响。

Numerical simulation of superhigh pressure water jet in rust remover

超高压纯水射流除锈机的数值模拟

The results show that the wake can be found in shroud/ suction corner and the jet does not exist near blade pressure side; the flow construction in the impeller did not prove to be the well known jet/ wake flow model.

试验表明，在前盖板／叶片吸力面拐角处存在尾流，但压力面不存在射流，叶轮内部流动结构与射流／尾流模型不符合。

Technology of Water Jet Shot Peening at High Pressure

高压水射流喷丸强化技术

Development of High Pressure Water Jet Combined with Machinery Cutter Cleaning Adhesion Tramcar Device

高压水射流联合机械截齿清理粘底矿车装置的研制

Application of High Pressure Spiral Jet Pile on the Connection Permeability Resistance of Continuous Concrete Wall& QC group overcome the difficult problems in the construction

高压旋喷桩在地下连续墙接头抗渗中的应用&QC小组攻克施工难题

Established indoor has simulated the test platform, the test result indicated that enhanced the revolving jet flow to break ground the effect to increase the jet flow power, and enhanced the jet pressure to the effect enhancement which broke ground is very obvious.

建立了模拟试验系统，试验结果表明，提高旋转射流破土效果必须增大射流功率，提高射流压力对破土的效果提高是很明显的。

Pressure fields measurements and flow losses around a row of short cylinder with jet impingement

带射流冲击短扰流柱排内的流动和损失

When the nozzle attached is similar to the first nozzle of jet spinning, the air pressure needed is only 0.5 bar, far smaller than that for the jet spinning nozzle, yet the problem of hairiness is solved to a great extent.

该喷嘴与喷气纺中第一喷嘴相似，所用气压为0.5bar，大大小于喷气纺纱中喷嘴的气压，防止与加捻方向相反的纤维产生新的毛羽。

Some parameters affecting the supersonic flowfield, including the total pressure ratio of jet to freestream, slot width of injection, and the angle of injection were studied in more detail.

探讨了射流/主流总压比、射流宽度、以及射流与来流夹角对射流穿透深度、分离距离等影响，揭示了二次射流推力矢量控制干扰流场的控制机理。

An analysis is made of the performance characteristics of the lower pressure waste steam jet refrigeration machine by using the gas dynamic function. The theoretical calculating formulas for specific steam consumption and throat area ratio are also derived.

本文利用气体动力函数分析了低压废汽喷射制冷机的工作特性，并导出了单位耗汽量和喉部面积比的计算公式。

The effect of some cutting parameters such as system pressure, stand off distance, traverse speed on the cutting process and cutting quality are examined by using a ultra high pressure abrasive water jet machining technology.

使用石榴石磨料，在高压磨料水射流数控切割机床上，研究了切割参数（压力、靶距、切割速度）对大理石切割性能（切口宽度、切口锥角、余纹角度）的影响。

Coal cutting equipment also known as high pressure hydraulic slotting machine is a set of equipment to improve low permeability coal seam gas drainage efficiency, which utilizes high pressure water jet technology to drill and cut seam in coal mining process.

煤矿割缝设备又称高压水力割缝机，是在煤矿开采过程中利用高压水射流技术进行钻孔和割缝，从而提高低渗透煤层瓦斯抽放效率的一套设备。

The main factors which affect the effcets of abrasive water jet machining are the water pressure, abrasive pa-rameters, traverse speed of nozzle and stand off distance of nozzle.

影响高压磨料水射流加工效果的主要因素是水压力、磨料参数、喷嘴的横向移动速度和喷嘴悬高等。

This thesis focused on the newly developed swirling jet negative pressure sand cleaning tool. Using the method of numerical simulation, optimized the geometric configuration of the tool.

本论文针对新研制的旋转射流负压冲砂工具，采用数值模拟的方法，对工具进行数值模拟和结构优化。

The effect of control pressure flow on two dimensional incompressible jet attachment

控制压力流量对定常不可压二元湍流附壁射流的影响