process construction的例句大全

The paper introduces the construction method of using bolted fixture to improve the form erecting process in brick-and-concrete composite construction and this method has also produced an obvious result.

文章介绍了砖混结构模板体系中应用螺栓夹具等改进的支模工艺的施工方法，并取得了明显的效果。

Construction process and monitor method of the filling embankment of highways

公路填石路堤的施工工艺与检测方法

To this', we on request Construction in construction process strict control good board upper formation steel bar submersion question, controls the good steel bar the position.

就此，我们要求施工单位在施工过程中严格控制好板上层钢筋的下沉问题，控制好钢筋的位置。

The process of construction, transportation and installation of SPAR platform is a huge project.

SPAR平台的建造、运输及安装过程是一个庞大的工程。

Combined with urban water supply works of Taiyuan the construction experiences of large casting ductile iron pipe are summarized from construction process, finished products protection, installation in knick point and other aspects. Which provides references for the construction of underground pipeline.

结合黄河水源太原市城市给水工程施工实例，从其施工工序、成品保护、变坡点的安装等方面，总结了大型球墨铸铁管施工中的经验，为给水工程地下管线的施工提供了参考。

Construction Process Analysis of Wu Gorge Bridge on Yangtze River

巫峡长江大桥施工加载过程计算

Meanwhile it does light-well point pump water and open-drainage in foudation pit to preserve desiccation in construction process.

同时对基坑内进行轻型井点抽水和明排水，以保持施工作业过程的干燥。

Influence of Construction and Impounding Process on the Stress of Super High Arch Dam

自重与初次蓄水对特高拱坝应力的影响

By enumerating the risk source in tunnel unkennel construction process, the analytic hierarchy process and fuzzy comprehensive evaluation methods were used to evaluate instability risk of tunnel portal. And the corresponding risk control countermeasures were proposed.

列举出洞施工过程中的风险源，采用层次分析法和模糊综合评价法进行隧道出洞洞口失稳风险评估，提出了对应的风险控制对策。

Three-dimensional numerical analysis method was used to study the characteristics of deformation and stress of surrounding rock and supporting structure on the process of tunnel unkennel construction. The comparative analysis of three-steps-seven-footwork tunnelling method and small pilot tunnel method were performed. 3.

采用三维数值分析手段研究隧道出洞施工过程中的围岩与支护结构变形受力特点，分别对三台阶七步法和超前小导洞法两种出洞施工方案进行对比分析。

In the highway blacktop design criterion ( TJT014-97), four methods are recommended to the value of the modulus of resilience of the roadbed. However, the limitation of the methods induce disconnection between the designing modulus index and the compaction in the process of field construction.

尽管现行《公路沥青路面设计规范》（TJT014-97）中，推荐了4种不同方法确定路基回弹模量值，但是由于这些方法的局限性，导致路基设计回弹模量取值与现场施工压实过程脱节。

The investment control of the construction engineering pierce through in the whole process of the project implementation.

建设工程投资控制贯穿于项目建设的全过程。

About Process Conditions and Construction of Polyurethane Casting Machines for Pilot Test

浅谈聚氨酯材料配方试验机的工艺条件和设备结构

Stress Analysis for Cemented CNG Storage Well and Its Construction Process condition of mailbox

全井筒固井储气井应力分析及施工工艺邮筒状态-邮筒式存储器的

The construction process of super-thick mass concrete of the comprehensive building of Luoyang state tax bureau is introduced.

介绍了洛阳市国税局综合楼超厚大体积混凝土的施工过程。

The detailed structural parameters of catwalk are discussed and their according factors which should be considered when design are introduced, what's more, the erection method and process for the construction of catwalk and its advertent proceedings are explained thoroughly.

对猫道的各结构参数作了系统的讨论，介绍了设计这些参数所需考虑的各种因素，并对猫道的施工架设方法、过程及注意事项作了具体的阐述。

Based upon analysis of construction process of GRC baffle wall works, from two aspects: installation technology of panel and decorative surface new methods are proposed to deal with cracking problems of decorative surface in order to improve construction quality of wall.

对实际工程中GRC板墙体的施工过程进行分析，从板条的安装工艺和装饰面层工艺两方面，介绍了新的解决墙体开裂问题的方法，以提高墙体施工质量。

Through detailed analysis and design system development process, the details of the system architecture, functional framework and modules, complete system design to meet the management requirements of the power construction in progress.

通过分析设计系统的详细开发步骤、系统架构、功能框架及模块等细节，建立全套的系统设计方案，满足电力线路施工中进度管理的要求。

Some developments of principles for construction process mechanics and some case history studies

施工过程力学原理的若干发展和工程实例分析

Pile displacements are affected by the extrusive effect of piling, pile intensity, axes distance and flow process of construction.

桩体位移受沉桩挤土效应、桩位密度、轴线间距以及流水作业顺序的影响；