program interrupt的例句大全

you might let your calling program know (through a non-interruptive approach) that an e-mail address might be missing.

您必须通知（通过一个不会产生中断的方法）调用程序，一个邮件地址将要丢失。

Finally the missile's flight environment was simulated by means of interrupt program, and the flight simulation test has been done.

最后，根据中断程序模拟的导弹飞行环境进行了模飞测试。

the software in this system includes a monitor program, a lcd display program, an interrupt service program, a computing program and so on.

该系统的软件主要包括监控程序、中断服务程序、计算程序和显示程序等。

the program design is based on bus time sharing and interrupt servicing.

程序设计基于中断服务和总线分时复用方式，实时更新各个电机的速度和方向。

it is proposed that data acquisition is controlled by the timing interrupt which is generated by the timer or counter of industrial control computer with std bus. the programing technique and detailed c language source code program are given out.

提出了一种利用STD总线工业控制机自身的定时器/计数器产生定时中断来控制数据采集的方法，给出了应用时的编程技术和具体的C语言源程序。

based on the hardware circuit designs and the depth knowledge of three-phase inverter modulation technique, phase lock technology and control technology, the system software is designed, including the main program design, interrupt service routine design and the main control software design.

在逆变器的硬件设计基础上，根据三相逆变器的调制技术、锁相技术和控制技术原理，进行了系统软件设计。主要包括主程序设计、中断程序的设计和主要控制软件设计。

The infrared incepting program went into interrupt after the timer was time out.

红外接收程序在定时时间到后进入中断.

The main program and interrupt service routine ( ISR ) realized by using modularized software design method.

软件采用模块软件设计的方法设计了控制系统主程序、中断 服务程序 及中断服务子程序.

The main program and interrupt service routine ( ISR ) are realized by using modularized software design method.

软件采用模块化软件设计的方法设计了控制系统主程序、中断服务程序及中断服务子程序.

The software of the controller incudes main programme and the realtime interrupt program.

软件部分包括主程序和实时中断程序.

The main program, interrupt service program and subroutine were designed by use of modeling develop ways.

分析了系统软件的功能,采用模块化软件设计方法,设计了控制系统主程序 、 中断服务程序以及子程序.

This code for AT 89 S 51 MCU external interrupt C language program code.

此代码为AT89S51单片机的外部中断C语言程序代码.

The flow chart of main program and interrupt subprogram of the time service device and the electronic clocks were presented in the system.

论文的软件编写采用C51，给出了授时器、电子时钟的主程序和中断子程序框图。

Then, a computer system would often run one simple sequential program at a time, and nothing could interrupt it or vie with it.

那时，计算机系统通常在同一时刻只能运行一个单独的程序，什么都不能打断它或者与它竞争。