propeller blade的例句大全

Cutting tool selection in the NC machining of propeller blade with a constant pitch

等螺距螺旋桨数控加工中的刀具选择

Design and Development of Interactive Center of Gravity Survey Testing Set for Propeller Blade

螺旋桨桨叶交互式重心测量实验台的设计与开发

Measurement of thickness of propeller blade

船舶螺旋桨桨叶厚度的测量

The whirl of the propeller blades three-blade marine type propelle agitator

三叶推进桨式搅拌器

In IMP thrusters, the motor stator ( core and winding) installed in the duct, the rotor ( permanent magnet pole) installed at the tip of with rings propeller blade leaves and appeared in the form of rings.

IMP推进方式中，电机的定子（铁心及绕组）安装在导管中，转子（永磁磁极）安装在带环螺旋桨桨叶的叶梢以环的形式出现。

Study of the Optimum Angle of Attack for the Propeller Blade

关于螺旋桨桨叶有利迎角的探讨倾转螺旋桨飞行器桨叶的气动设计研究

The propeller blade has been mounted.

推进器的叶片已经安装好了.

Creep-Feed Grinding Experiment in Propeller Blade Fir-Shape Tenon of 261P Turbosupercharger

261P涡轮增压器叶片枞树形榫齿深磨试验研究

Study on optimum combination of blades of five-blade controllable-pitch propeller and static balancing methods of the whole propeller

五叶调距桨的桨叶优化组合及整桨静平衡方法研究

The aeroacoustic field generated by a transonic two-blade Hartzell propeller was calculated by using Kirchhoff method.

本文采用Kirchhof方法计算双桨叶Hartzel跨音速螺旋桨的远场气动噪声.

A method for calculating the acoustic pressure of a propeller due to blade thickness and steady surface pressure loading ( including the effect of forward motion) is presented in this paper.

介绍一种螺旋桨厚度噪声和载荷噪声声压时间历程的计算方法。

application of cda blade shape in the design of high pressure and high efficiency propeller fan

CDA叶型在高压头、高效率轴流通风机设计中的应用

flat blade is taper shape, and with waving hinge and shimmy on hinges connected to the propeller hub.

桨叶平面形状是尖削的，用挥舞铰和摆振铰连接到桨毂上。

renewal of oil leakage at blade pivot in adjustable blade propeller turbine

转桨式水轮机桨叶枢轴漏油改造

fixed blade propeller type turbine

定轮叶旋桨式水轮机

this equipment is comprised of a jacketed cylinder with ellipsoidal head and tapered bottom, three-blade propeller, gear motor, etc.

JCG本设备由附夹套的椭圆封头、锥形底的圆筒体、三叶搅拌浆、减速电动机等组成。

The changes of hydrodynamics of propeller under different amount of jetted air were estimated with panel method, in which air layer is taken as the thickness of blade.

将气层作为桨叶的厚度，用面元法估算了不同充气量时螺旋桨水动力性能的变化；

And on the basis of Solid Dynamics Analyzing, the intensity and rigidity of propeller are checked by using ANSYS software, in order to optimize the thickness of blade.

基于固体力学分析，应用ANSYS软件对桨叶进行强度和刚度校核，优化了桨叶的厚度。

The blade angle of controllable pitch propeller should be examined and adjusted.

可变螺距螺旋浆的桨叶需要检查与调整.

The propeller is threaded over the shaft, and when mounted between the magnets, the heavy blade will drop to the bottom.

螺旋桨是螺纹在轴上，而当安装之间的磁石的著磁，沉重的刀片将降至底部。