pull test的例句大全

Pull thrust test is a destructive bond pull test, so only selected groups of solder joints are measured and can not cover all of the solder joints.

由于拉推力检测是破坏性检测，只能对部分焊点进行抽检而无法进行全检。

This paper studied the influence of the different conductor material such as AU| Pd-Au, the different film thickness. 125 ℃. 300 ℃ thermal aging and temperature cycle on bond strength with two methods of destructive wire bond pull test and bond contact resistance test.

本文使用焊点破坏性拉力试验和焊点的接触电阻测试两种方法，研究了导体材料（Au、Pd&Au）、膜层厚度、125℃、300℃热老练和温度循环对焊点键合强度的影响。

Study of on-line Photogrammetry System for the Measurement of Extending Rate in Draw-and-pull Test of Reinforcing Steel Bar

钢筋拉伸实时摄影测量方法的研究

A new intelligent pull test system for anchor bolt is introduced.

介绍一种智能型锚杆拉力测试系统.

3d parameter design method of mine pull test instrument for bolt

矿用锚杆拉力计的三维参数化设计方法

The Development of Intelligent Pull Test System for Anchor Bolt

智能型锚杆拉力测试系统的研制

And for a quick quality check, do the "pull test."

迅速检查质量，做“拉力测试”

Do you know what a trigger pull test is?

你知道那枪的板机拉力是多少 吗 ?

page pull test a test which is performed on adhesive bound book pages to determine the secureness with which pages are bound.

书页拉力测试胶装书籍，鉴定书页的装订稳固度的测试方法。

Dry coating which is removed when subjected to the specified tape pull test is not acceptable.

在规定转带测试中会被抹去的干膜不可接受.

Load-pull test of motor wheel truck is important for pull performance examination and service quality security.

电动轮自卸车的负载拉功试验是检验其牵引性能、保证使用质量的重要手段.

Dry spray which is removed when subjected to the specified tape pull test is not acceptable.

在规定拉带测试中会被抹去的干燥喷漆物不可接受.

Interface Study of Smart Composite Material with Optical Fiber by Single-Fiber Pull-Out Test

单丝拔出法在光纤智能复合材料界面研究中的应用

They were then loaded on a tensile machine ( Instron 1122) for slow-pulling, fast-pulling experiment and reciprocating fatigue test at 20N load peak value separately.

将其随机分成三组，在Instron1122拉力实验仪上分别进行慢拉、快拉和20N峰值负荷条件下的反复疲劳实验。

in order to reduce the necking effect of gabion mesh and lateral deformation during pull-out test, special clamping system was developed.

试验改进了筋材的夹持方法，有效地限制了试件的横向变形和在拉拔过程中的颈缩效应。

to test the horizontal pull-out strength of the connecting rods by pull-out strength testing machine.

采用拉力测试机器测试连接棒的横向拔出力。

the axial maximum pull out strength test of full thread cancellous bone screws with different length

三种不同长度全螺纹松质骨螺钉最大轴向拔出强度的测试

Make the anchor ground-based test, study the impact of inner press on the allowable pull-out load of anchor and the resistance, make seal test and working stability test and failure test.

进行地面试验，研究内注压力对锚杆许用拉拔载荷和抗剪切力的影响，以及锚杆密封性、承载稳定性试验和失效试验。

Research on Pull out Test of Pressure type Anchor Rod

压力型锚杆的抗拔试验研究

The predicting formula of the drawbar pull of driven wheels running on the sand is obtained by model test.

通过模拟试验，得出了驱动轮在砂地上行驶时的挂钩牵引力预测公式。