pulse input的例句大全

In terms of hardware, it has been designed the hardware composition principle of architecture, the pulse input system and physical therapy output system as well as each module circuit of the core and expansion board.

在硬件设计方面，设计了系统硬件的组成原理架构，详细研究了理疗仪的脉象输入系统和理疗输出系统；开发了理疗仪核心板和扩展板上的各个模块电路。

The steering transient response test ( steering wheel angle pulse input) show that the resonance of All Terrain Vehicle is about 1.2 Hz.

转角输入脉冲试验表明全地域车的谐振频率约为1.2Hz。

Influencing factors of steering wheel angle pulse input test result

影响汽车方向盘转角脉冲输入试验结果的因素

The measuring and controlling card includes analog input card, analog output card, digital input card, digital output card, pulse input cars, thermocouple input card and RTD input card.

测控板卡的种类包括模拟量输入板卡、模拟量输出板卡、数字量输入板卡、数字量输出板卡、脉冲量输入板卡、热电偶输入板卡和热电阻输入板卡。

Based on the analysis on the relationship between the two-region model and two-flow domain model for soil solute transport, the prediction functions of these two models are compared by the experimental data obtained from continuous input test and pulse input test.

本文在分析描述土壤溶质迁移的两流区与两区模型的区别与联系的基础上，利用连续和脉冲输入情况下的试验资料对两区和两流区模型的预测能力进行了比较和分析。

The synchronous machine based on Field Programmable Gate Array ( FPGA) is combined with the integrate circuit and transistor, to realize multiplex pulse and step-signals synchronized with input signal.

该同步机以FPGA为核心，与集成电路、晶体管分立元件相结合，实现对输入脉冲触发转换、脉冲成形以及驱动输出，最终产生多路同步触发信号。

In the middle trigger mode of the analog input card, the pulse signal can be completely captured.

利用采集卡的中间触发方式实现了脉冲信号的完整捕获；

Parameters of all five models are obtained based on the same compound pulse test data of an 80 Ah Ni-MH battery pack with 320 cells in series and hence five corresponding power input simulation models based on Matlab/ Simulink are set up.

以320单体串联的80A.h镍氢电池组为研究对象，基于同一组复合脉冲试验数据，辨识各模型的参数，进而建立各模型基于Matlab/Simulink的功率输入仿真模型。

Furthermore, the expression of stationary bit error rate of system output corresponding to equiprobability quaternary pulse amplitude modulation ( PAM) input signals was deduced.

给出了当输入信号为等概率的四进制脉冲幅值调制（PAM）时，系统输出理论渐近误码率计算公式。

Calculations show that the attenuation of sine input pulse is higher than Heaviside input pules in the elastic medium. The longer the action time of sine input pules, the higher the attenuation.

计算结果表明，在弹性介质内正弦输入脉冲的衰减比Heaviside输入脉冲的衰减快，正弦输入脉冲的作用时间越长，衰减越严重。

After the external input servo ( empennage) reset command, posture control circuit output PWM pulse signal to reset the servo and start FLASH into the writing mode to record data.

外部输入舵机（尾翼）复位命令后，姿态控制电路输出PWM脉冲信号进行舵机复位，并启动FLASH进入写状态，记录数据。

Experimentally, the input pulse sequence with the same cycle and with the unequal cycle act on H-H model respectively. The experimental results show that the output symbol sequence corresponds with the input sequence.

分别将等周期和非等周期的输入刺激信号作用于H-H模型，得到输出脉冲序列对应的符号序列，实验结果表明输出脉冲符号序列与输入脉冲间存在着一定的对应关系。

Its input ends are suited to any kind of signals, such as analog, digital and pulse quantity. Its output signals are sent out with divided time mode. The system may be used in parameter acquisition of any production process.

提出一种小型通用型数据采集系统的结构，输入端子可接任何形式的信号，如模拟量、开关量和脉冲量，输出信号采用分时传送方式输出，适用于各种生产过程的参量采集。

In the circuit design work, the entire system is devided into three modules: pulse control unit, keyboard input unit and digital display unit.

在电路设计部分，将整个系统设计成三个模块：脉冲控制单元、键盘输入单元和数码管显示单元。

The Multiple Input Pulse Width Modulation Control With Forecast Self-Correction for Large Dead Time System

大时滞系统的多输入预报自校正脉冲调宽控制

The study of chirped-pulse amplification in the gain saturation regime shows that the linear frequency chirp of input pulse tends to suppress the effects of self-phase modulation.

通过对增益饱和状态下自相位调制效应的研究，提出利用入射脉冲的线性频率啁啾抑制自相位调制的影响。

Due to the frequency selectivity and high insertion loss of SAW device, the input must be high pulse whose spectrum width can cover the center frequency of SAW tap delay line.

由于SAW器件具有频率选择性及较高的插入损耗，使得它的输入必须为高脉冲且脉冲的频谱宽度能覆盖SAW抽头延迟线的中心频率。

A theoretical analysis of the shaping the ultrashort optical pulse by an optical processing system, and the expression for the output optical pulse of the input gauss optical pulse is presented.

给出了一种利用光学傅里叶交换产生各种形状短光脉冲的方法，并且推导出了入射光脉冲为高斯型脉冲时的输出脉冲的数学表达式。

Performance influences from optical loop loss, input pulse power and pumping power are profoundly analyzed in order to find best conditions for system.

然后，设计实验系统，研究光环路损耗、输入激光脉冲功率和光放大器泵浦功率等参数对大尺寸测量系统性能的影响，确定系统最佳工作条件。

Experiments were carried out to test the CDs with 40Gbit/ s and 10Gbit/ s RZ pseudo-random code optical pulse as the input sequences. The experimental results are in accordance with the theoretical values.

分别针对40Gbit/s和10Gbit/sRZ码伪随机光脉冲两种输入序列进行了实验，得到的实验数据与理论曲线基本吻合。