pulse load的例句大全

According to the duration of explosion load, the reaction of structure can be divided into three regions: pulse load region, static state load region and dynamic load region.

根据爆炸荷载持续时间与结构构件特征周期的比例关系，结构构件在爆炸荷载作用下的反应可以分为脉冲荷载区、准静态荷载区和动态荷载区。

The shape of pulse load approaches half sine wave.

脉冲荷载形状近似半正弦波；

Simulation results show that, APF controlled by SVPWM ( Space Vector Pulse Width Modulation) can quickly and precisely compensate the harmonic and reactive components of load current.

仿真结果表明，电压空间矢量脉宽调制SVPWM（Space Vector Pulse width Modulation）控制的APF能对负载电流中的谐波和无功分量进行快速精确的补偿。

The mathematic models of the 12-pulse uncontrolled bridge rectifiers which work in different load current and reactor factor are analyzed and concluded in the paper. The operations of the 12-pulse uncontrolled bridge rectifiers with and without IPT are simulated by Matlab/ Simulink.

城市轨道交通供电的电气计算部分，本文采用Matlab/Simulink仿真了不带IPT和带IPT接线的十二脉波整流机组在不同负载电流、电抗因素下工作情况，并分析和总结了其数学模型。

The major load which brings about vibration of workshop is pulse by overfall. The vibration and it's safety determine whether the new structure is suitable.

引起溢流厂房振动的主要荷载是在厂房顶渲泄高速水流时产生的脉动，脉动荷载引起溢流厂房振动与安全是决定这种新型的水电厂房结构成立与否的重要课题。

first, a model of transformer has been built and analysed to formulate the expression of pulse on the load capacitor, which can demonstrate the influence of major parameters of transfomer on the charging time and efficiency of energy-transmitting.

首先，对空心变压器的理论模型进行了分析，在得到了输出脉冲电压的表达式的基础上分析了变压器各主要参数对脉冲充电时间和充电时能量传输效率的影响；

the results of numerical computation show that pulse transmission line of multi-small-loading capacitance with proportional spacing can be well compensated by the equivalent distributed capacitance method.

数值计算结果表明等效分布电容法对均匀分布的多个小负载电容脉冲传输线具有很好的补偿作用。

This pulse gets wider and taller as the motor is put under more load.

这脉冲得到更广泛和更高作为电动机是把下更多的负荷。

In addition, a stepper motor driver was designed for drive chip carrier, which could enhance the load capacity of the pulse generated by NI motion control card.

此外，本文设计了一套与NI运动控制卡协同工作的步进电机驱动器，增强运动控制卡脉冲信号的带负载能力，驱动芯片台工作。

The Software design contains trigger pulse module, power factor detection module, load rate calculation module and energy-saving controller algorithm module.

软件设计方面主要分为触发脉冲模块、功率因数检测模块、负载率计算模块和节能控制算法模块的设计。

the investigation of pulse forming network with variable load impedance

变载脉冲形成网络的研究

but the step motor efficiency is low, the ability is not big, load drag pulse equivalent cannot too big, speed range is not big.

但步进电机的效率低，拖动负载的能力不大，脉冲当量不能太大，调速范围不大。

after testing the endurable voltage and current values of various rated current of igbt modules, the equipment with the suitable module could generates below 200 hz of 300 a transient current pulse when the output load is in 2 Ω and 3 μ h.

实验测试了不同额定电流IGBT的耐迅变电流冲击参数，当线路输出负载为2Ω、3μH时，可以得到200Hz以下近300A迅变脉冲。

the impedance matching circuit is used for improving the load capacity of the circuit so as to improve the pulse ultrasonic wave form;

所述阻抗匹配电路用于提高电路的负载能力，改善脉冲超声波形；

in order to drive a high impedance load such as hpm sources, it is necessary to commutate fcg's long pulse width, high-current and low voltage pulse to a short pulse with high voltage.

为用FCG驱动象HPM源这样较高阻抗的负载，必须使用脉冲功率调制电路把FCG产生的低电压、大电流、上升时间长的电压脉冲转化为高电压、上升时间短的脉冲。

thermal analysis of the hl-2a divertor plates under dumping of intense pulse thermal load

大脉冲热负荷下HL-2A偏滤器靶板的热分析

Measurement and analysis of high speed high voltage ultrashort pulse on capacitive load

高速高压超短脉冲在容性负载上的测量及分析

Research on Pulse Radiation Characteristics of the Dielectric Parallel-loaded Wire Loop Antenna

并联介质加载环天线的脉冲辐射特性研究

An equivalent load density model based on pulse function for distribution networks is presented.

提出了以脉冲函数为基的等效负荷密度模型简化配电网分析的方法。

Design of a matching circuit between pulse power supply and capacitive load based on frequency response analysis

基于频响分析法的脉冲电源与容性负载间匹配电路设计