pulse switch的例句大全

the pointer position of the rotary vane meter is equipped with a pulse switch used for transmitting a pulse signal to the control system.

在所述的叶轮式水表的指针部位设一将脉冲信号传递给控制系统的脉冲开关。

The rate equation was solved to analyze the influence of upconversion effect to the output power, slope efficiency and threshold power in CW operation and the pulse energy, pulse width and peak power in Q-switched operation.

通过速率方程的求解模拟分析了上转换效应对连续运转Ho激光器输出功率、斜率效率和阈值功率的影响以及对调Q运转Ho激光器单脉冲能量、脉冲宽度和峰值功率的影响。

We realized passive Q-switch of flash lamp pumped Nd: YAG laser with ion-implanted GaAs, which produce pulse as narrow as 62 ns.

利用离子注入GaAs实现闪光灯泵浦Nd：YAG激光器被动调Q，脉冲宽度为62ns。

Magnetic pulse compressor ( MPC) with thyratron as discharge switch used in Ti: Sapphire laser was put forward for the first time.

首次提出了将磁脉冲压缩开关应用于钛宝石激光器中，由磁脉冲压缩开关和闸流管组合作为放电开关。

Experimental results show that intensity instability of output Q-switched pulse doesn ′ t exceed 4.3%, and time jitter doesn ′ t exceed ± 4 ns.

实验结果为：输出调Q脉冲强度起伏不超过43%，时间抖动小于±4ns。

The pulse jitter of gain-switched Fabry-Perot laser with external cw-light injection was experimentally investigated by using harmonic spectrum analysis. The time jitter is 0.905 ps and amplitude noise is 2.83%.

利用谐波频谱分析法测量了外连续光注入下增益开关F-P激光脉冲的抖动，时基抖动为0.905ps、振幅噪声为2.83%，并与取样示波器的测量结果进行比较。

The dynamic process of a Q switched double pulse ruby laser with μ s time separation is presented. The approximate value of Q switch control voltage is deduced and the design of main control circuit and the tested results are given.

阐述了μs时间间隔红宝石双脉冲Q开关激光器的动力学过程，求出Q开关电压峰值的近似值，并给出主要控制电路的设计和测试结果。

For achieving ultra-high speed optical time-division multiplexing transmission, optical soliton transmission and high-speed optical switch, the generation of high repetition rate, ultra-short optical pulse is one of the key technologies.

高重复频率、超短光脉冲的产生，是实现超高速光时分复用传输、光孤子传输和高速光交换的关键技术之一。

This article introduces the work principle of PLC controlled pulse packs dust catcher, The exterior code switch can be the timer to control the set value, and the design method of using exterior matrix circuit to reduce the output and multiply the control points is described.

文章介绍用PLC自动控制脉冲袋式除尘器的工作原理，指出用外部拨码开关，可作为定时器控制设定值，叙述使用外部矩阵电路减少输出点、增大控制点的设计方法。

The Methods of Measure Pulse Timing Jitter in Gain-Switched Semiconductor Laser

增益开关激光脉冲时基抖动的测量方法

Synchronous Pumped A-O Q-switched All Solid Pulse Laser

同步泵浦声光调Q全固态脉冲激光器

characteristics of q-switched cw yag lasers with pulse modulation

脉冲调制连续YAG激光器调Q特性研究

The circuit of this device is formed the source, pressed frequently by the pulse changer, photosensitive resister and power switch three parts make up.

该装置的电路由脉冲形成源、压频变换器和光耦与功率开关三部分组成。

The fundamental concept of pulse power technology is introduced, and the category and characteristic of switch devices in pulse power technology field are summed up. The advantages of high-power and ultra-high-speed semiconductor switch RSD ( Reversely Switched Dynistor) are illustrated.

本文介绍了脉冲功率技术的基本概念，归纳了脉冲功率技术领域开关器件的种类与其特性，指出了大功率超高速半导体开关RSD（Reversely Switched Dynistor）的基本优势。

Angle displacement quantities of guide pulley and count reposition position of cutter displacement which are obtained through approach switch are translated into pulse signals;

采用接近开关将检测到的导向滑轮的角位移量和钻具位移的计数复位位置转换为脉冲信号；

Research on methods of restrain IGBT switching-off voltage pulse in high-power inverter off peak telephony rate

大功率逆变电源IGBT关断电压尖峰抑制研究非高峰期电话价目表

Study of low jitter and small drift switch pulse generator

低抖动小漂移开关脉冲发生器研究

In front knowledge foundation, present paper use resonance-switch technical design one too for high-pressured pulse electric capacity charge high-pressure soft switching power supply.

在前面知识的基础上，本论文利用谐振开关技术设计了一台给高压脉冲电容充电的高压软开关电源。

With the development of semiconductor industry, in many applications such as pulse power and variable power supply, application of solid-state switch instead of radio tube and traditional electromagnetic relay will be possible and the trend, and solid state switch will be used in more fields.

随着半导体技术的发展，在脉冲功率及可变电源等应用中，使用固体开关代替电真空器件与传统的电磁式继电器已成为可能和趋势，并应用于更广泛的领域。

The switch works by passing a pulse of current between the tip and the surface.

那个开关通过在末梢和表面之间传输电流脉冲工作。