pump power的例句大全

Considering the high-power diode-end-pumped Tm: YLF laser, the effect of the thermal lensing on the output beam quality is un-negligible.

考虑到大功率二极管激光器端面泵浦条件下，激光晶体的热透镜效应不应被忽略。

Economic Dispatching Strategies and its Operating Experience of Guangzhou Pumped-storage Power Plant

广州抽水蓄能电站机组经济调度及运用经验

In the design process, some important and difficult problems of carrying out are solved such as how to measure high-power pump and flow, hardware compatibility, signal acquisition and processing, and anti-interference technology.

在设计过程中，解决了如何测量大功率水泵及流量、硬件兼容性、数据采集和处理以及抗干扰技术等难点问题。

Safety management on excavation construction of inclined shaft for water conveyance system of pumped-storage power station

抽水蓄能电站输水系统斜井开挖施工安全管理

With analysis, considers that heat pump and accumulation of electric energy heat supply is the direction of developing electrical power market, Energy conservation of residential buildings and the combination supply of cooling and heating by electricity is the national policy of sustainable development.

通过分析，认为热泵和电蓄能供热是开拓电力市场的发展方向，建筑节能和冷热电联供是可持续发展的国策。

This paper introduces the repair welding method of a circulating water pump for 200 MW Unit 6 in Matou Power Plant, including the procedure selection against concrete defects, proper heat treatment, build-up weld, and other measures.

文章介绍了用焊接的方法修复马头发电总厂6机200MW汽轮机循环水泵轴缺陷的全过程。

Speed-governing and economics analysis of unit 3 ash pump in Shaoguan B power plant

韶关电厂B厂3号灰渣泵调速改造及经济分析

Vibration analysis and treatment of steam turbine for Unit 3 feed-water pump A in Zhanjiang Power Plant

湛江发电厂3号机组A给水泵汽轮机振动问题的分析处理

This paper presents the vibration analysis and treatment of No. 2 bearing of the steam turbine for Unit 3 turbine driven feed water pump A in Zhanjiang Power Plant.

叙述了湛江发电厂3号机组A汽动给水泵汽轮机2号瓦振动问题的分析及处理的整个过程，指出造成2号瓦振动大的主要原因是不平衡及轴瓦刚性差。

Analysis on damage to turning for Feed Pump Turbine B of Unit 2 in Zhuhai Power Station

珠海发电厂2号机组B给水泵汽轮机盘车损坏的分析

The arithmetic formulae were analyzed and deduced, including lift of pump, shaft power, output power, efficient of pump, NPSH, installing height and the max installing height. Based on the characteristic parameters from the pump examination a pump characteristic curve was processed.

分析推导了水泵扬程、轴功率、输出功率、泵的效率、实际汽蚀余量、安装高度和最大安装高度的计算公式，选用实验水泵检测其性能参数，绘制了水泵的实际性能曲线。

The upper guide bearing pads of unit 2 in Jiangsu Shahe Pumped-storage Power Plant had been burned to damage during commissioning period.

江苏沙河抽水蓄能电站2号机组在调试过程中曾出现上导瓦烧损事故。

Design and Fabrication of Steam Turbine Power Generator and Primary Pump Motor by HEC for Nuclear Power Station in China

哈电（HEC）为我国核电站设计制造汽轮发电机和主泵电机之过去现在和将来

Sucker rod is a power transmission component in rod pumping oil system, driving pump plunger up and down for reciprocating motion in oil Wells work, which carries alternating load.

抽油杆是有杆抽油系统中传递动力的部件，在油井工作中带动泵柱塞作上下往复运动，承受交变载荷。

It is an important factor for the perfect matching between the maximal input power of the hydraulic oil pump and the maximum output power of the engine in the design process of the hydraulic shovel.

液压油泵的最大输入功率与发动机的最大输出功率之间的匹配问题是液压挖掘机设计过程中的一个重要内容。

In order to solve the problem, a bladder power pump driven by an external electromagnet was proposed.

针对此问题，本课题提出了一种体外电磁驱动的膀胱动力泵。

The serious situation of scaling of slurry pipeline in ash hydraulic transport system in the No. 8 stove in Yancheng power plant is introduced. Moreover, the electric current inside the ash pump is far below normal rating.

介绍了江苏盐城发电厂8号炉水力除灰系统灰浆管道严重结灰垢及灰浆泵电流远低于额定值，并影响灰渣浆泵安全运行的情况。

The innovation for the control system of steam driven feed water pump in the first term project of Daba Electric Power Plant

大坝电厂Ⅰ期汽动给水泵控制系统改造

The experimental study results of LiBr absorption refrigeration and heating dual-usage system working in refrigeration cycle and type ⅱ heat pump cycle are presented. The power of the system is supplied by 65-75 ℃ hot water from a simulated solar energy collector system.

报道了溴化锂吸收式制冷和供热两用装置在由模拟太阳能集热器提供的65&75℃热水驱动下，实施制冷循环及Ⅱ型热泵循环的试验研究结果。

working together with zhongan serial hydraulic rescue tools, bjq63/ 0.6 hydraulic motored pump is one of the power sources.

BJQ63/0.6型液压机动泵与“众安”系列液压破拆工具配套使用，为各破拆工具的动力源之一。