pv work的例句大全

The main work about this thesis contains two parts discussed as below: Firstly, three control strategies of PV inverter are analyzed in detail is based on the theory of photovoltaic inverter.

本论文围绕这两个部分展开了研究，主要做了以下工作：首先，以光伏逆变器的理论为基础，详细分析光伏逆变器的三种控制策略。

The total power of at the same time in the work load must be less than the household solar PV power output power.

同时工作的负载的总功率之和必须小于太阳能户用电源的输出功率。

The results show that the variance of PV cells in one module will bring some bad effects, not only causes mismatch losses but also short circuit, and makes the module out of work.

结果表明组件中电池参数不一致将会造成很坏的影响，不仅会造成失配损失，严重时还可以造成组件的短路，使组件停止工作。

The simulation results on the coordinated control scheme show that, the wind and PV can work on the maximum power point and the battery realize charging and discharging.

对协调控制方案进行了仿真，结果表明，风力机和光伏电池分别实现了最大功率点跟踪，蓄电池完成了充放电，系统根据负载的变化协调控制风光储的输出。

Through the load control, PV system can work at the max power point in a variety of illumination and temperature conditions, achieving the max power point tracking.

通过对负载的控制，可以使光伏阵列在各种不同的日照和温度条件下都能工作在最大功率点，实现逆变器的最大功率点跟踪。

It also analyzes the application of Perturbation and Observation Method in MPPT which enables the PV batteries to work at MPP with Maximum Power Output ( MPO).

主要浅析了扰动观察法在最大功率点跟踪时的运用，并对传统扰动观察法进行了改进，从而使得光伏电池始终工作在最大功率点并输出最大功率。

Mismatched PV strings timely isolation from system, the impact on the system is presented by the detection of power matching. Modular PV system can work in several different system structure.

通过功率匹配检测，及时将失配光伏串从系统隔离，防止失配光伏串对系统造成影响，使组合式光伏发电系统可以工作在几种不同的系统结构。

here, the subshell command du -sh work | cut -f1 yields the total size of the work directory in a format compatible with pv.

在这里，子shell命令du-shwork|cut-f1以与pv兼容的格式生成工作目录的总大小。

For the PV battery charging system, research on the MPPT algorithm about converter duty cycle regulation based on the character of battery and work status of the circuit. From the research result shows that the system can catch the 90% energy from the input.

针对光伏蓄电池充电系统，根据对蓄电池充电特性的研究结合主电路工作特性，研究调节变器占空比的MPPT算法，在实现系统中得到验证其能源利用率可达90%以上。