quenching的例句大全

PL spectra and Thermal gravimetric analysis ( TGA) showed that the flakes and flowers have narrow PL peak widths and lower intensity than that of powder, which is likely caused by the solvents quenching.

其荧光光谱和热重分析表明，微米片状和花状结晶态的荧光峰宽较粉末窄，单色性较好，其荧光强度较弱，可能是由存在9.7wt%溶剂所致。

Based on the thermal effects, induction current can heat the surface of the work piece, make the surface heat fast and then refrigerate quickly. This modern industrial quenching technology is called induction heating surface hardening.

感应加热表面淬火是利用感应电流通过工件产生热效应，使工件表面局部加热继之快速冷却的现代工业淬火技术。

The thermal quenching of PL intensity for samples annealed at 900 ℃ measured at temperatures from 15K to 300K is 30%.

测量温度从15K变化到300K时，样品（900℃，30min退火的GaN：Er）的1540nm处PL温度猝灭为30%。

Thermal Shock with Flame Jet and Water Quenching of Plasma-sprayed ZrO_2 Coatings

等离子喷涂ZrO2涂层的火焰喷烧和水淬热冲击

Effect of quenching temperature on the microstructure and thermal fatigue life of ti_2alnb-based alloy

淬火温度对Ti2AlNb基钛铝合金组织和热疲劳寿命的影响

Heat source device with plasma arc quenching is of great capacity for its high thermal efficiency and low cost.

等离子弧淬火热源装置热效率高，成本低，有巨大的发展潜力。

Upon repeated exposure to the relatively high interfacial temperatures be-tween the steel surface and the oil, petroleum oils undergo thermal and oxidative degradation leading to significant varia-tion in their quenching performance.

由于不断暴露在钢与油接触面间相对较高的温度中，石油制品油遭受热降解和氧化降解，使得其淬火特性发生明显变化。

For miniature lamp, it is most important to improve the thermal quenching.

在紧凑型节能荧火灯中热猝灭的改善是十分重要的。

The thermal quenching of Er PL tends to decrease with an increase in the N concentration in Er doped a-Si: H.

随着N掺杂浓度的增加，Er PL的热猝灭效应下降。

Exploition and Application of Quenching Equipment of Remnant Forging Thermal Quenching for Automotive Axle Tube

汽车轮毂轴管锻造余热淬火装置的开发与应用

The good isothermal quenching process is austenitizing at 800 ℃ and thermal quenching at 280 ℃ for 3 hours.

该钢理想的等温处理工艺为800℃奥氏体化+280℃等温3h。

The Er PL thermal quenching is restricted due to the large mismatch between the Si-nc bandgap energy and the Er transition energy.

利用Si-nc带隙和Er~（3+）跃迁能量之间较大的不匹配可以抑制温度淬灭效应。

Abnormal temperature dependence of UV emission integrated intensity of ZnO and ZnO: In samples is observed. The mechanism of the negative thermal quenching was investigated.

在变温PL光谱中，ZnO和ZnO：In晶体的紫外发射积分强度出现反常的负热淬灭现象，研究了这种非单调的温度依赖现象产生机理。

The behavior of these centers for various thermal quenching and anne-aling procedures provides evidence that these hole traps result from supersaturated vacancy, and probably are related to a certain large vacancy cluster.

从这些深中心缺陷的不同淬火和退火行为，可以认为缺陷中心主要是样品在激光退火过程中产生的过饱和空位所形成的，而且可能是与某种大空位团有关。

With the Ba 2+ substitution for the Ca 2+ or Sr 2+ into the crystall, the luminescence properties of Eu 2+ has changed: the emission peak lowered and the thermal quenching temperature increased.

当用Ba2＋离子代替Ca2＋或Sr2＋离子进入晶体时，Eu2＋离子的发光特性发生改变：发射峰的峰值降低，热猝灭的温度升高。并采用位型坐标理论给予解释。

Using differentiated thermal analysis quenching method, the solidification process of CG cast iron with various percentage of compacted graphite particles is investigated.

本文应用微分热分析液淬法研究了不同蠕化率蠕铁的一次结晶过程。

The ion-implantation damage defects and thermal stress during quenching step are responsible for the formation of dislocations.

位错的形成与离子注入引进的损伤和淬火过程中的热应力有关。

This paper briefly introduced the mechanism of charge transfer luminescence in scintillators containing Yb3+ ions, and the host effect on the thermal and concentrations quenching.

本文简要介绍了掺Yb3+闪烁晶体的电荷迁移发光的机理以及基质晶体对温度猝灭与浓度猝灭的影响。

Numerical analysis of temperature and thermal stresses fields in quenching 7075 aluminum alloy thick plates

7075铝合金厚板淬火温度场及热应力场的数值模拟

The development of thermal damage with increasing quenching tempera-ture difference for three types of Al_2O_3 ceramics has been investigated.

研究了三种Al2O3陶瓷的损伤状态随热震温差变化的趋势。