radius tip的例句大全

To provide a theoretical basis for the conical stylus cone angle selection. ( 2) Analysis of the stylus tip radius and the stylus static pressure causing timber roughness parameter measurement error, calculation of the roughness measurement error value caused by the different tip radius.

分析触针针尖圆角半径和触针静压力引起的木材粗糙度测量误差，计算不同针尖半径造成的粗糙度测量误差值。

Utilizing quantized fracture mechanics, we investigated the non-continuously fracture behavior of defected graphene and the crack tip radius of various vacancies.

采用量子化断裂力学研究石墨烯的非连续性断裂行为，并获得其特征缺陷尖端半径。

The dimensionless tip velocity increases and the tip radius decreases with the increase of anisotropy.

随着各向异性的增加，枝晶尖端生长速度增加，尖端半径减小；

Compensating of tip radius is a key problem in CMM. It has a great influence to its measuring accuracy.

测头半径补偿问题是三坐标机测量中的一个关键问题，影响着三坐标机的测量精度。

All rigid projectiles shall have a tip radius of not less than2mm.

所有刚性射弹物不能有半径小于2毫米的尖头。

Determined are the applicable velocity ranges of various models for steady growth of dendrite, the tip radius of which agrees well with experiments.

在此基础上，给出了各种稳态约束枝晶生长模型的适用速率范围，并与实验结果进行了比较。

The line width of nanostructures is influenced by many factors such as tip curvature radius, detained time in the base surface, scanning speed, humidity, surface roughness etc.

尖端曲率半径、针尖在基底表面滞留时间、针尖扫描速度、空气湿度、表面粗糙度等均会影响纳米结构的线宽。

A model is developed for the calculation of the initial rotor tip vortex core radius aiming at eliminating the empirical parameters of the tip vortex in rotor free-vortex wake analysis.

建立了一个旋翼桨尖涡初始涡核半径计算模型，用于消除旋翼自由尾迹分析中桨尖涡涡核半径依靠经验设定的现状。

By means of SiO 2 mask and SF 6 etching corrosive, the cantilever beam with tip is shaped by reactive ion etching once through operation. The probe has been shaped by wet corrosive and the tip radius is about 50 nm.

以SiO2为掩模，SF6刻蚀硅，用RIE与各向同性湿法化学腐蚀相结合使悬臂梁探针一次成形和用湿法腐蚀锐化探针，针尖半径约50nm。

According to the analysis on the carbon imprints of electrode tips, three parameters were defined to represent the tip surface characteristics: relative radius ( Rr), edge concentration ( EC) and eccentricity ( ECC).

基于对电极压印的分析，定义了3种电极头表面特征参数：相对半径（Rr）、边缘聚集度（EC）和偏心度（ECC）。

The results show that during welding process the contact radius increases gradually, the highest temperature is always located at the center of the electrode tip surface, while the electrode stress and current density both concentrate at the edge of contact region.

结果表明：所考察的焊接条件下，接触半径在焊接过程中逐渐增大，电极端面的中部温度最高，而电极压力和电流密度均在接触区边缘集中。

Hence, jet tip velocity produced by direct annular initiation is higher than that of plane initiation, and plane initiation higher than point initiation. It is also concluded that the jet tip velocity of plane and annular initiation increases as the initiation radius increases.

环形起爆形成的射流头部速度高于面起爆的，面起爆高于点起爆的，并且随着起爆直径的增大，面起爆与环形起爆所形成的射流头部速度逐渐增大。

the shape and radius of crack tip plastic zone of type i cracks for concrete structure is given in this paper.

针对混凝土结构，画出了不同参数b情况下的裂尖塑性区半径变化图。

This paper introduces application and design of full radius hob on tooth tip.

介绍了齿顶整圆弧滚刀的应用和设计.

All rigid projectiles shall have a tip radius of not less than 2 mm.

所有刚性射弹物不能有半径小于2毫米的尖头.

Tree initiation voltage and electrical tree shape of different curvature radius of needle tip were measured.

采用针板电极结构,测量了不同针尖曲率半径的起树电压和电树枝形态.

The methods of reducing centrifugal fan fixed in oil gas machine are studied by altering the gap between cases and tip of rotor, radius of tongue of case and inclining the tongue of case.

采用改变蜗舌间隙、蜗舌半径及倾斜蜗舌等方法对家用油烟机主要噪声源的离心风机进行降噪研究。