rate of polymerization的例句大全

The thermal polymerization of phenylacetylene occurred to a negligible extent below 100 °; at 100-160 °, the rate of polymerization increased with increasing temperature.

苯乙炔的热聚合在100°以下很少发生，在100&160°，聚合速度随温度升高而迅速增加。

the ratio between the rate of polymerization of fibrin monomer and maximum absorbency ( reflecting the polymerization of plasmic fibrinogen molecules).

纤维蛋白单体聚合速率与最大吸光度的比值（反映血浆纤维蛋白原分子的聚合功能）。

main outcome measures: ① the rate of polymerization of fibrin monomer ( taken as the comprehensive predictor for the concentration and function of plasmic fibrinogens).

主要观察指标①纤维蛋白单体聚合速率（反映血浆纤维蛋白原浓度和功能的综合参数）。

The rate of polymerization is proportional to 1.62 power of [ AN ] and 0.62 power of [ DMT ] .

聚合速度与AN浓度 的1.62次方、DMT浓度的 0.62 次方成正比.

This paper reports the effect of polyvalent ions on the rate of polymerization of silicic acid.

本文在较广PH值范围研究了多价离子对硅酸聚合速度的影响。实验证明，硅酸聚合中的盐效应具有静电效应和化学反应两种机理。

The results showed that the Ammonium Ceric Nitrate used as initiator is high effective, the rate of polymerization reaction is satisfactory and the capacity of water-absorption for the resin is high.

结果表明：硝酸铈铵引发剂的引发效率高，聚合速度快，树脂的吸水能力强。

both the rate of polymerization and the maximum conversion percentage increased with increase either in tbh or amine concentration.

当[TBH]/[TEA]的克分子比增加时则聚合速度增加，最高转化率也增加。

The effects of initiators and thermal initiation on a reaction rate, molecular weight and molecular weight distribution of products in a mass polymerization of styrene were investigated.

考察了热引发方式和不同种类、浓度下的引发剂引发方式在苯乙烯的本体聚合中对聚合反应速率和产品的分子量及其分子量分布的影响。

The reaction rate constant and activation energy of soybean oil thermal polymerization reaction were determined by analysis of the change of viscosity.

以大豆油为原料，根据热聚合反应过程中黏度的变化确定反应的速率常数及热聚合反应的活化能。

Compare to the thermal-initiated polymerization, the condition of UV-irradiated polymerization is milder and the rate is faster.

且与TEMPO调控下的热聚合相比，苯乙烯的光聚合反应条件温和，且聚合速率快。

In this paper, the polymerization rate and average molecular weight of thermal-initiated polymerization of styrene in the range of 120~ 200C were studied. The polymerization rate was found to be proportional to the square of styrene concentration, thus a second-order initiation is inferred.

在120～200℃内，对热引发苯乙烯本体聚合的速率及平均分子量进行了研究，得到聚合速率与单体浓度二次幂有关，据此可以推论引发速率也和单体二次幂有关。

The emulsifier content and feed rate affect latex swelling and shell polymerization by the making a change of latex number and total reaction rate coefficient respectively.

乳化剂量和加料速率分别通过影响胶粒数和总体反应速率系数而对胶粒溶胀和壳层聚合反应产生影响。

Enhancement of ultrasonically initiated emulsion polymerization rate of styrene using aliphatic alcohols as hydroxyl radical scavengers Studies on the Reaction of OH Radical with Hexachlorobenzene

OH自由基捕捉剂加速超声引发乳液聚合的研究六氯苯与OH自由基的反应

With the increase of temperature and initiator concentration, the polymerization rate of VC-IBVE-HEMA increased.

KPS浓度和聚合温度增加使VC-IBVE-HEMA乳液共聚速率增加。

Effect of Polyvalent Ions on the Rate of Silicic Acid Polymerization

多价离子对硅酸聚合速度的影响

Decomposition rate constant of oxidation-reduction initiation systems in free radical polymerization

自由基聚合氧化还原引发体系的分解速率常数

Finally, using GA-BP network for the modeling of VAC polymerization rate soft-sensing.

最后，将GA-BP网络用于VAC聚合率软测量建模。

The experimental results show that scanning rate, polymerization upper potential, circle number of cyclic voltammetric polymerization, temperature of polymerization and polymerization time, etc.

结果表明，聚合电位，循环伏安法的扫描速率、终止电位、扫描周数，聚合温度，聚合时间等对传感器的响应特性有显著影响。

And the rate of the polymer with 6 of polymerization degree had greater than that of the polymer, which polymerization degree was 18.But they had nearly the same content of residual amic acid at 20 min.

聚合度为6的聚酰胺酸反应速率稍大于聚合度为18的聚酰胺酸，但在反应初期较聚合度为18的慢，且它们的剩余聚酰胺酸的质量分数较为相近。

Research on the Soft-Sensing and Predictive Control of Vinyl Acetate Polymerization Rate

醋酸乙烯聚合率软测量与预测控制方法研究