ratio analysis的例句大全

The Analysis and Calculation of the Snaking Contact Surface Area Ratio in Rotary Forging Process(ⅱ) Circular Ring Work-piece

摆辗加工中摆头接触面积率的分析与计算&（Ⅱ）圆环形工件

Regression analysis of saline soil improvement ratio of plants

植物对盐渍土壤改良率的回归分析

The analysis indicates that the combat readiness ratio of the mine clearing vehicle is 99.12%, and its expectation of availability and instantaneous availability is 95.8% and 93.86% respectively after working continuously for four hours, which has better supportability than that of others.

分析表明，该扫雷装备在无限保障能力的条件下，其4h连续作业后，战备完好率为99.12%，平均可用度和瞬时可用度分别为95.8%和93.86%。

New calculating formula has been put forward for reducing ratio of wall thickness of cylinder-type pipe in bending, by using regressive analysis and curve fitting, which has been proved to be with higher calculating accuracy than that of formula being used at present.

采用回归分析和曲线拟合方法，提出圆管无芯弯曲壁厚减薄量新的计算公式。经验证该公式比目前实际采用的变薄量计算公式具有更高的计算精度。

This paper is based on reinforcement ratio of longitudinal tensile steel with yield point in flexural reinforced concrete beams, and through theoretical analysis and economic comparison, a reasonable reinforcement ratio of longitudinal tensile steel for reinforced concrete beams is presented.

该文仅从有屈服点钢筋在钢筋混凝土梁内纵向配筋率入手，通过理论分析、经济比较，研究确定钢筋混凝土受弯构件-梁的合理纵向配筋率。

In this paper we present the principle of a digital divider with ratio of decimal fraction and structure of the circuit then we analysis the intrinsic jitter of the device Digital FIGURE

提出了一种具有小数分频比的数字分频器的设计原理，具体给出了这种分频器的电路结构，并对这种数字分频器的抖动性能进行分析和计算

A Rapid Analysis Method about Compounding& Ratio of Cement Mortar in Architectural Decoration Engineering

建筑装饰工程砂浆的配制与配比快速分析法

And this paper analysis and research the whole system and establish mathematical model, result in which the changing power-load adjusting is the control way of the best Tip Speed Ratio.

本文分析研究并建立系统数学模型，根据系统模型确定最佳叶尖速比的控制采用可变功率负载调节方法。

In order to discuss the in-plane stability of the steel portal frames with different ratio of depth to span which is subjected to roof uniform loading, the ANSYS finite element program is used to perform geometrically nonlinear analysis.

应用ANSYS有限元程序，在均布荷载作用下，对不同高跨比的门式刚架进行了弹性几何非线性分析。

Analysis of the System Error and Pressure Correction in Air Specific Heat Ratio Measuring Experiment

空气比热容比测定实验的系统误差分析及压强修正

At the same time, dynamical analysis for a given bridge has been done through the software MIDAS, and the relation of between basic frequency and sag ratio of stress-ribbon footbridges and frequency wave on the base of given sag have been educed.

同时，通过计算软件MIDAS对拟定桥梁进行动力分析，得出人行悬带桥的基频与垂跨比的关系以及特定垂度下的频率波形。

The analysis shows that the average stock held by these investors traded at a price/ earnings ratio of 23 times.

分析显示，这些投资者所持股票的平均市盈率为23倍。

The other module is knowledge base module, which is based on assessment result of DEA combined with monitoring information such as voltage qualification rate, line load, capacity-load ratio, etc. to get improving measure of distribution line through reasoning analysis.

根据DEA的计算方法的评估结果，结合配电网的电压合格率、线路负载率、容载比等监测指标建立知识库，通过推理分析给出线路改善的建议措施。

Tumefaciens and 169 kanamycin resistant strains were isolated. PCR analysis of this generation revealed that 35 of 169 were positive, and the ratio was 20.7%.

然后采用农杆菌介导法转化生菜（皱叶生菜），获得卡那霉素抗性植株169株，对转基因T0代植株进行PCR检测，有35株为阳性，阳性率为20.7%；

impact on the pharmaceutical industry innovation efficiency factor analysis and how to realize the reasonable ratio of investment and how to accelerate the patent conversion rate will be further research in this direction.

对于医药制造业的创新效率的影响因素分析和如何实现投入的合理配比以及如何加速专利的转化率将是本文进一步研究的方向。

An Empirical Analysis of Concentration Ratio on Chinese Cigarette Industry

中国卷烟工业集中度实证分析

Productivity, Concentration Ratio and Scale Economy& An Empirical Analysis on the Wrist Watch Industry

生产率、集中率与规模经济&对手表行业的实证分析

An example of electric market is used and its concentration ratio index is got through fuzzy evaluation and analysis.

并以某市发电市场为例，通过对其进行模糊评估分析，得出该市场集中度等极指标。

The mainstream analysis of merger is traditional structural analysis which concentrates on market share and market concentration ratio.

传统上并购的主流分析方法是以市场份额和市场集中度为基础的结构分析方法。

Analysis of Factors Affecting Instantaneous Speed Ratio between Workpiece and Roller of CWR

楔横轧轴类零件轧件与轧辊瞬时速比影响因素分析（板坯初轧机的）立辊横梁