recrystallization的例句大全

In situ recrystallization during elevated temperature deformation in fe_3al based alloy

Fe3Al基合金高温变形过程中原位再结晶现象

The test results showed that Nb could prevent recrystallization of deformed lath martensite structure at 600~ 680 ℃, and the aged structure was tempered sorbite kept lath martensite phase direction with no ferrite particles discovered.

试验结果得出在600～680℃范围内，Nb能阻止变形马氏体组织的再结晶，时效组织主要为保持板条马氏体位向的回火索氏体，未发现粒状铁素体。

Based on the hypothesis that work-hardening and the softening of recrystallization was in dynamic equilibrium when superplastic tensile, this paper presents a new method to measure cavitation exponent based on the material tensile curve.

基于超塑性拉伸的加工硬化与再结晶软化处于动态平衡的假设，本文提出一种根据材料拉伸曲线测量空洞分数的新方法。

Recrystallization occurs during tensile deformation at a high temperature and T1 phase dissolved in matrix. ( 3) The fracture of the alloy appears obvious hierarchical characteristics, with dimple, when tension specimen at Room temperature.

高温变形时出现动态再结晶，T1相消失。（3）2198（T851）合金室温拉伸断口有明显的分层断裂的特征，并带有韧窝。

Also, the thinner the strip, the better the magnetic properties, the more fully the tertiary recrystallization develop.

硅钢极薄带厚度愈薄，磁性能愈好，三次再结晶发展得越完善。

Static recrystallization all occurs in the range of 3~ 200 s interval time when double-pass compression test at constant temperature is conducted.

恒温双道次压缩时，在3￣200s的间隔时间内均发生了静态再结晶。

The influence of thermomechanical treatment on the recrystallization behavior of al-li-cu-mg-zr alloys

热机械处理对Al-Li-Cu-Mg-Zr合金再结晶的影响

Effect of intermediate thermomechanical treatment on the recrystallization of al-li-cu-mg-zr alloy containing bismuth

形变热处理对含铋Al-Li-Cu-Mg-Zr系合金再结晶的影响

The results showed that the low-temp toughness of weld metal could be improved markedly through the welding method of two beads per layer, so that the recrystallization occurred in the middle zone of weld.

结果表明：通过采用每层两道的焊接工艺，使对接焊缝中心部位全部发生重结晶，是焊缝金属低温韧性提高的关键。

Deformation determines recrystallization score when it has same deformation temperature and heat preservation time. Deformation in the materials produced more distortion and can increase the recrystallization driving.

变形温度和保温时间相同时，变形量的大小决定了再结晶分数的大小，变形量的增大使材料内部产生了更多的畸变能，使再结晶的驱动力增大。

The Influence of Cold Rolling on the Formation of Recrystallization Texture in Titanium Sheet

冷轧形变量对钛板材再结晶织构形成的影响

By treating this precipitate with nitrous acid followed by a recrystallization process, copper ( II) nitrate was recovered in82.32% yield.

该沉淀经硝酸溶解和浓缩结晶可以得到硝酸铜，其回收率为82.32%（以铜含量为基准）。

A Study on Dynamic Recrystallization Model for a Boron Bearing Microalloy Steel

含硼微合金钢动态再结晶模型的研究

Recrystallization Behavior of Microalloy Strip Steel with Ni during Finish Rolling

含铌微合金带钢精轧过程中的再结晶行为

Antifreeze proteins ( AFPs), with the thermal hysteresis activity, are wildly distributed proteins which can change the growth and inhibit the recrystallization of the ice.

本文讨论了影响抗冻蛋白活性的因素，介绍了抗冻蛋白热滞活性和重结晶抑制效应的定量测定方法。

The Role of Thermal Diffusion in Laser Recrystallization

热传导在激光再结晶中的作用

Antifreeze proteins ( AFPs), known as thermal hysteresis proteins have the ability to inhibit ice nucleators and ice recrystallization.

抗冻蛋白（AFPs），也称热滞蛋白，具有降低溶液的冰点，抑制重结晶的能力。

Antifreeze proteins ( AFPs) are the thermal hysteresis proteins that have the ability to modify the growth and inhibit the recrystallization of the ice.

抗冻蛋白是一类具有热滞效应、冰晶形态效应和重结晶抑制效应的蛋白质。

The compression deformation test at the temperatures between 850 ℃ and 1 050 ℃ with strain rate 0.1~ 10 1/ s of steel B72LX 、 B82LX has been carried out using the Gleeble-1500 thermal simulation machine to study the dynamic recrystallization behavior of the steel.

采用Gleeble-1500热模拟试验机上对B72LX、B82LX钢进行变形温度为850℃~1050℃应变速率为0.1~101/s的压缩变形试验，研究了这两个钢种的再结晶规律。

The recrystallization temperature and the strenth of molybdenum thermionic cathode wires are increased greatly by addition of about 4wt% content of rare earth oxides.

4wt%左右稀土氧化物的加入，能显著提高钼热阴极丝材的再结晶温度和室温抗拉强度。