reheater的例句大全

Analyses wall temperature characteristic of reheater according to the test data.

根据某锅炉末级再热器壁温的测量结果，分析了该再热器的壁温特性。

State Evaluation& Principle of 1025t/ h Boiler High Temperature Reheater Out of Control

1025t/h锅炉高温再热器失控机理及状态评估

Hydraulic Test Block Valves Applied to Reheater System of Once-through Boilers

水压试验用堵阀在直流锅炉再热器系统的应用

Live steam reheater vapor filled thermoelectron type rectifier

充蒸汽热电子式整流器

Through analyzing the welding defect of reheater tube, The reasons of defect formation and the measure of disposal are discussed.

通过对现场热段再热器管段焊接所产生的缺陷分析，讨论了缺陷产生的原因及处理的方法。

Investigation on Superheater and Reheater Thermal Deviation of Supercritical Pressure Boilers

超临界压力锅炉的过热器、再热器热偏差问题探讨

Theoretical and Experimental Study of the Impact of In-boiler Swirl Number on the Thermal Deviation in a Reheater

炉内旋流数对热偏差影响的理论和试验研究

This method is used to calculate the heat distribution and thermal deviation of the final stage reheater of a power boiler, and the calculating results conform to the measuring results.

利用该方法计算了某电厂锅炉末级再热器的流量分配和热偏差情况，与实测结果相吻合。

Under the same secondary air distribution mode SW will increase with a reduction in boiler load. The maximum thermal deviation factor of the reheater will increase with an increase in SW value.

在同样的二次风配风方式下，SW随锅炉负荷的降低而增加，再热器的最大热偏差系数随SW增加而增加。

Overall design is introduced including volumetric heat release rate of furnace, exit gas temperature, hot air temperature, efficiency of boiler, furnace dimension, superheater, reheater, attemperator, etc.

还介绍了主要热力特性数据和总体设计，包括炉膛容积热强度、炉膛出口烟温、热风温度、锅炉效率、炉膛尺寸、特性和各受热面、调温方式等。

The temperature field and thermal stress of tee pipe sockets for exhaust pipes to atmosphere from reheater have been analyzed by using the finite element method, the data at time points of 50, 200, and 400 minutes after startup being discussed.

进行了再热器对空排气管三通管座的温度场和热应力的有限元分析，并选取机组起动后第50min、200min和480min3个点的数据加以讨论。

Evaluations of the Temperature Control Properties of Reheater

再热器调节性能的评价

Live steam reheater Application of heating energy efficiency skill in air heating system

供暖节能技术在蒸汽换热供热系统中的应用

Water-cooled wall, superheater, reheater and economizer are the main component of boiler heating surface.

在锅炉中，水冷壁、过热器、再热器和省煤器是主要受热面。

The moisture separator reheater which used in nuclear power station was a complex structure, the NDT was according to British standards and French ALSTOM project standards.

核电站用汽水分离再热器结构复杂，无损检测按英国国家标准和法国ALSTOM公司工程标准进行。

The desuperheat water system of low-multiplying forced circulation tower-type boiler made in Czechoslovakia is introduced. The Characteristics of the reheater and superheater of each stage are introduced too.

本文介绍了捷制1650T/H低倍率强制循环塔式锅炉减温水系统以及各级过热器、再热器的汽温特性。

Study on high temperature steam corrosion of inner tube of superheater and reheater in boiler

过热器和再热器管内壁的高温水蒸汽腐蚀研究

First, the dynamic mathematical models for the typical components of the heat recovery steam generator are built up on the basis of fundamental physical laws, which are composed of the single-phase region models ( economizer 、 superheater and reheater) and evaporating zone model.

首先，从基本物理定律出发建立了余热锅炉典型部件动态数学模型，其中包括单相受热环节（省煤器、过热器和再热器）模型和蒸发区模型。

Analysis of Oxide Skin Exfoliation and Operational Characteristics of Boiler 2 Final Reheater in Zhujiang Power Plant

珠江电厂2号锅炉末级再热器氧化皮剥落与运行特性分析

Analysis on over temperature tube-burst of the 1025 t/ h boiler's reheater and its transformation

1025t/h锅炉再热器超温爆管分析与改造