relative density的例句大全

The check item includes the dose, relative density, PH value, dynamics check, assaying and microbial limit check.

检查项下内容包括装量、相对密度、PH值、动力学检查、含量测定、微生物限度检查。

coke--determination of true relative density

焦炭真相对密度测定方法

Effect of Relative Density on Compressibility of Al-Si Closed-Cell Aluminum Foam

Al-Si闭孔泡沫铝材料的压缩行为

The results were as follows: ( 1) The color of milk was no abnormal, and the tissue of milk was a slight viscous phenomenon in the five cities; the relative density of 12 samples were lower than the national standard in Wuwei city.

结果表明：（1）五市乳样色泽无异常，有轻微的粘稠现象，武威市有12份样品相对密度低于国家标准。

Compared with irregular pore shape porous aluminium, the relative density of porous aluminium with spherical pore is lower.

不同孔径相混合的孔结构可有效的降低泡沫铝的相对密度：与不规则孔结构泡沫铝相比，球形孔结构泡沫铝的相对密度更低。

The porosity defect is that in certain area inside the cast ingot exist small cellular voids relatively equally distributed, slight difference in mechanical properties, obvious plastic volume deformation and variation of relative density governed by the spherical stress tensor.

疏松缺陷是一定区域上相对均匀分布着的蜂窝状小空洞，疏松区域上各处的力学性能相差小，表现为明显体积塑性变形，材料的相对密度变化主要依赖于应力球张量。

The target characteristics including relative density, microstructure, content of Ti rich β phase were introduced. The relationship between target characteristic and technical conditions was researched.

研究了靶材致密性、富Ti的β相含量、微观结构均匀性与工艺条件的关系。

Mass loss rates of fir leaf litter appeared consistent with the taxa and individual relative density of soil fauna.

不同孔径凋落物袋内土壤动物的类群和个体相对密度与凋落叶的质量损失率呈现相对一致的变化趋势。

By the density test of blow-drying and stoving of non-aridity core sample from asphalt pavement, the bulk volume relative density and compactness can be calculated under different test conditions.

通过对沥青路面上钻取的非干燥试件进行风干和烘干试验，计算不同试验条件下心样的毛体积相对密度和压实度。

The effects of the relative density of mixture, the content of Al particle, the size of Al particle, the heating rate, the content of dilution Fe on the thermal explosion point temperature and the thermal explosion delay time are analyzed.

对工艺参数如混合物的相对密度、Al粉的相对含量、Al粉粒度、加热速率、Fe的相对含量对热爆点温度和热爆延滞时间的影响做了分析。

And the holding time of pressing pressure has little influence to he relative density.

保压时间对于坯体相对密度的影响很小。

Ceramics were sintered at 950 ℃ by adding ZnO as sintering assistant in CZP powder, and the relative density, average thermal expansion coefficients, strength resistance, and microstructure of the ceramics were measured and observed.

添加ZnO为烧结助剂，将CZP粉体在950℃下烧结成陶瓷，测定和观察所制备陶瓷的相对密度、平均热膨胀系数、抗压强度和显微结构。

Effect of sintering atmosphere on the relative density and conductive properties of Ni-Fe spinel ceramics

烧结气氛对Ni-Fe尖晶石陶瓷致密化和导电性能的研究

The uniform axis compression capability of spherical pore Al alloy foam was studied and the relationship between compression strength and relative density was acquired.

研究了球形孔泡沫铝合金的单轴压缩性能，得到了抗压强度与相对密度的关系；

Combining with the experimental results, model parameters can be regressed by relative density and relative size.

根据试验结果，回归出模型参数与颗粒物性相对密度、相对粒度的关系。

The lithium disilicate glass-ceramics and their composites with high relative density were prepared by melting method and hot-pressing technology, respectively.

本文分别采用熔融法和热压烧结工艺制备了致密的二硅酸锂微晶玻璃及其复合材料。

The results indicate that salt stress has little effect on the absorbency, pH, relative density, solid matter, water and Mg 2+ content of aloe.

结果表明，盐胁迫对芦荟全叶原汁的吸光度、pH值、相对密度、总固形物、水分含量和镁离子含量的影响较小，但对多糖和钙离子含量的影响较大。

Having low relative density or specific gravity.

具有很小的相对密度或者比重。

The relative density of the composites is the main factor of influencing the wear rate. The composites with high density can remain relatively low wear rate of ( 0.5~ 2.1)× 10-3 mm3/ m under the experimental conditions.

复合材料相对密度对磨损率的影响较大，接近理论密度的复合材料在本研究试验条件下能保持较低的磨损率，最低可达到0.5×10-3~2.1×10-3mm3/m。

The highest density reached 7. 49 g/ cm3 after sintering, with a relative density of 97. 74%;

烧结试样密度最高为7.49g／cm3，其相对密度为97.74%；