residual depth的例句大全

Experimental Research and Analysis of Welding Residual Stress of the Tensile Anchorage Region; Study on Drawing Force of Root Layer in Masonwork Affected by Anchor Bolt Type and Anchor Depth

斜拉桥锚拉板区域焊接残余应力试验研究分析锚栓类型、锚固深度对基层砌体拉拔力影响的研究

The basic principle involves drilling a small spherical pit in diameter and equal one radius in depth in the structure, measuring the relaxed strain by electrical-resistance gages and calculating the original residual stresses.

它用球形刀具钻小球坑，通过电阻应变片的变化，测量释放应变，然后计算出残余应力。

Microhardness test and residual stress measurement were done along the depth of piston rod after induction hardening to compare with the results of calculation.

对感应淬火处理的活塞杆进行了沿深度方向的显微硬度试验和残余应力测试。

This technique used in the present analyzer can non-destructively measure light metals' residual stresses with depth resolution, such as beryllium, by altering measuring and evaluating method.

该方法利用现有仪器，通过改变测定技术和计算方法，可以无损测定铍等轻金属制品表面残余应力及沿层深的分布。

In practical application, to use density compensation method impetrated forwardly residual gravity anomaly, then to use the quasi-neural network BP algorithm invert two 2D density interfaces simultaneously, to fit up depth anomaly of two interfaces, and predicting coalfield on this basis.

在实际应用中，先用密度补偿法正演求取剩余生力异常，然后利用拟神经网络BP算法同时反演两个二维密度界面，拟合求得两个界面的深度异常，在此基础上预测煤田。

X ray measurements of PALEOTECTONIC RESIDUAL STRESS with depth along the Red River Fault Zone

红河断裂带测区古构造残余应力随深度分布X射线测量

This article introduces a new measurement method by X-ray. The sin2 ψ method is combined with the grazing incident X-ray diffraction technique to obtain the depth profiles of the residual stress in the ground samples.

本文介绍了一种残余应力测量新方法，该方法联合使用sin2ψ法和掠入射X射线衍射法从而得到残余应力在试件中的深度分布。

The method gained residual moveout by focus depth analysis and CRP ray-tracing, which avoided tedious pick-up of travel-time in prestack reflection tomography.

该方法通过聚焦深度分析和CRP射线追踪来获得剩余时差，避免了叠前反射层析成像繁重的旅行时拾取工作。

Due to residual stress induced by laser shot peening can be deeper in depth.

水约束层可以提高等离子体的压力和脉宽,已经成功应用于激光喷丸工程化加工.

Properties of expanded area including cold work and residual stresses . Depth of TTS crevice.

胀管区域的特性包括冷加工及残余应力.

The width and depth of laser transformation hardening zone and residual stress distribution were measured experimentally.

实测了激光相变硬化区的宽度和深度及残余应力分布.