residual method的例句大全

Analysis of Shell Construction With Arbitrary Initial Imperfection by the Spline Weighted Residual Method

用样条加权残值法分析具有初始几何缺陷的壳体结构

The article has applied the weighted residual method and laplace changing to analyze the plastic dynamic response of a simple circular plate, the influence of elastic foundation on it and drives its residual deflection and the terminal time.

应用加权残值法和拉普拉斯变换，分析弹性基础上简支圆板的塑性动力响应问题，弹性基础对薄板塑性动力响应的影响，并且给出板的残余挠度和终止运动时间。

A Weighted Residual Method for Solving Sloshing Problems in Tanks with a Vertical Axis of Symmetry

具有铅直对称轴容器内液体晃动问题的加权残数解

An approximate solution on ultimate load of a circular plate under radial and lateral loads is derived from equations by subdomain Weighted Residual Method ( WRM) and point by point WRM.

本文应用加权余量法中的子域法和配点法，求出了均匀圆板在径向和横向均布荷裁作用下的极限荷载的近似解。

Determination method of the rational anchorage length of anti-slide pile based on unified strength theory and weighted residual method

基于加权残值法和统一强度理论抗滑桩合理锚固深度的确定方法

Using the well-known weighted residual method and finite element procedure, a nonlinear static analysis parallel with effective stress dynamic analysis has been made.

采用著名的加权剩余值法和等参数有限单元法，对坝体进行非线性静力分析和非线性有效应力动力分析。

finally, the weighted residual method is also applied to modify and complete the principle of least dissipation of energy to represent the transport process of available energy.

最后采用加权余量法，对力表述和流表述的最低能量耗散原理进行了补充和修正，建立了完整描述可用能传递过程的变分原理。

The residual method is generalized to topology identification for power electronics circuits ( PEC ) in this work.

该文将残差分析推广应用到电力电子电路的拓扑辨识当中.

the generalized weighted residual method is employed to simplify the partial differential equation of motion.

研究二长直电流间载流导线的横向非线性振动,采用广义加权残值法将偏微运动方程简化.

The weighted residual method by Monte Carlo for random numerical analysis of structures

结构随机分析的Monte Carlo加权残值法

Approximate solution of grinding force has been resulted by weighted residual method from grinding bar's deformation.

本文从磨杆的变形反推磨削力的角度,应用加权残数法导出了近似解.

A method for determining the distribution of residual stresses in a thin-walled cylinder

薄壁筒形件残余应力分布的测定方法

Experimental Research of Weld Residual Stress Relief by Tensile Load Method

焊接残余应力拉力载荷消除法的实验研究

Fault information was obtained by analyzing residuals with fuzzy residual evaluation, which overcome a high rate of misinformation associated with the threshold evaluation method.

从残差中提取故障信息，实现推力器故障的检测与分离.提出采用模糊诊断方法分析残差信号，克服了阈值判断法误报率高的弱点。

Residual stress measurement of porous silicon thin film by substrate curvature method

基片曲率法在多孔硅薄膜残余应力检测中的应用

Measurment and analyse of residual stress distribution in thin wall cylinder by x ray method

薄壁圆筒件残余应力沿层深分布的X射线法测试与分析

A Study of Residual Life for the High Temperature Tube by Constitutive Relationship and Finite Element Method

用本构关系及有限元法研究高温管道剩余寿命

Residual stress test of spiral spring using the cutting method

切割法测取螺旋弹簧的残余应力

After using this method to eliminate semicircular and quadrantal deviations, the residual deviation is within ± 1 °;

这时，用本方法消除半圆和象限自差后，其剩余自差均在±1°以内；

The use of orthogonal test method for residual stress testing found that step length on residual stress test results are most significant, impact of slit second and counting time of impact are not significant.

利用正交试验法进行残余应力测试发现：步长对残余应力测试结果的影响最显著，狭缝的影响次之，计数时间影响不显著。