rod milling的例句大全

Tool Wear Modeling on Special Spiral Rod Milling Based on Power Signal

基于功率信号的异形螺杆加工刀具磨损建模

Firstly the variable cutting parameters of spiral rod milling are analyzed to extract the eigenvalue of vibration and power signals. Then the mapping between the signal eigenvalue and the tool wear value is established.

该方法针对螺杆加工中变切削参数的工况，提取了振动信号和功率信号的刀具磨损特征值，并建立了信号特征值与刀具磨损量之间的映射关系，从而得到刀具磨损模型。

In the process of high speed wire-rod milling, micro-tension and automatic loop control are usually used, to assure the precision of wire sectional size, and to increase the productivity and the wire quality.

在高速线材生产中，大都采用微张力和自动活套控制，以保证轧材断面尺寸精度，提高生产效率和产品质量。

Tool wear modeling method for spiral rod milling is presented.

介绍了一种螺杆铣削过程刀具磨损建模的方法.

research on machining the slender rod with weak rigidity by the orthogonal turn milling

弱刚度细长杆正交车铣加工的研究

this drill grinder is a portable type, grinding2, 3, 4, 6blade of general end milling , tungsten rod directly open blade as well.

本机为傻瓜便携式，可研磨2刃、3刃、4刃、6刃等通用端铣刀，也可用钨棒直接开出刃口。

New method for online tool wear estimation in spiral rod numerical controlled milling is presented.

介绍了一种在线估算螺杆数控铣削中刀具磨损量的新方法。

With the emerging of the complex component and difficult processing materials, people hope that can use simple electrodes ( for example, rod-electrodes) as the same milling cutter for the conventional forming EDM.

但随着复杂构件和难加工材料的不断出现，由于传统的机械加工方法在这方面的加工有局限，人们非常希望能用简单电极（如棒状电极）像铣刀一样进行电火花成形加工。

Research on tool wear Intelligent modeling of special spiral rod numerical control milling

异形螺杆数控铣削刀具磨损智能建模研究