roller end的例句大全

meanwhile, the improvement advices for the structure and maintenance of the roller end clevis are provided.

并对辊端叉头的结构和维护提出改进意见。

analysis of the structure and strength for cross universal coupling used at roller end of 3500 mill

3500轧机辊端联轴器结构与强度分析

NIB: Green roller defect on the small end radius; caused by taper die failure. A sharp protrusion on the small end of the roller.

由于圆锥模具缺陷造成的半成品滚子小端倒角缺陷，滚子小端有尖锐的突出。

This film was one exhilarating roller-coaster ride from beginning to end.

整部电影都贯穿了过山车般的刺激感。

Intelligent Measuring System for End Face Run-out of Tapered Roller Bearing

圆锥滚子端面侧摆智能检测系统

application of lateral caging device and end cross beam strengthening to replacement of roller bearing

横向限位装置与端横梁加固在辊轴支座更换中的应用

the deep end-cavity roller reduces its maximum contact stress by 22.33 percent than the common column roller, and the depth of its deep end and the diameter of its notch are optimized to 4.4 mm and 5 mm respectively.

与普通圆柱滚子相比，凹端圆柱滚子最大接触应力降低22.33%，其优化结构参数为凹端深度4.4mm，凹口直径5mm。

needle roller with ball end

球头滚针

Life is a roller coaster emotional ride that lasts from the beginning to the end.

生活就是一艘永不停止行驶的货轮.

The balance quality of roller and distribution of permissible unbalance on the end surface were determined.

确定了辊体的平衡品质以及允许不平衡量在校正面上的分配.

The roller large end face run-out of tapered roller bearing ( SDW) is an important quality index for tapered roller bearing.

圆锥滚子基准端面摆动SDW（端面侧摆）是圆锥滚子轴承的一项重要质量指标。

Auto-measuring for Roller Large End Face Run-out of Tapered Roller Based on Data Fusion

基于数据融合的圆锥滚子端面侧摆自动检测

By means of adopting preheating before welding, low hydrogen welding and heat treatment after welding and some other steps, the built-up welding repairing of the crackle in 650 mm roller tip end was successfully achieved.

通过采取焊前预热、低氢焊接和焊后热处理等措施，成功地实现了650轧辊端头断裂的堆焊修复，即以焊代换。

The end-faces of upper and lower crimping rollers not aligned resulted in clearance between side plate and end-face of crimping roller where broken fibers became black because of.

原因主要是上、下卷曲轮的端面不对齐，侧面板与卷曲轮端面产生间隙，间隙内的碎丝经摩擦高温作用而发黑。

Influence of adjustment error of tapered roller spherical basic end face grinder on basic end face form

圆锥滚子球基面磨床调整误差对基面形状的影响