rolling ring的例句大全

railway rolling stock. brake discs with cast iron ring.

铁路车辆.带铸铁制齿冠的制动盘

control method design for feed rate of idle roller in cold ring rolling

环件冷辗扩芯辊进给速度规范设计

rolling mill roll neck bearing with sealed ring

带密封圈的轧钢机轧辊轴承

cold rolling forming for outer ring of single freewheel of bicycle

自行车飞轮飞壳的冷滚轧成形工艺

research on the following motion rule of single guide roller in cold ring rolling

环件冷辗扩中单辊随动导向运动规律研究

its guide apparatus features that the guide roller for rolling flat steel has 1-3 ring slots on its circumference.

本发明的导卫装置其改进是扁钢导卫导向轮的外圆开制成1-3道环型圆弧凹槽。

dynamics analysis of guide roller system in ring rolling machine

环轧机形位辊系统动力学分析

simulation research on radial-axial large ring rolling technology

大型环件的径轴向轧制工艺模拟和研究

rolling bearings--snap ring groove and snap ring on outer ring--dimensions and tolerances

滚动轴承外圈上的止动槽和止动环尺寸和公差

Ring rolling mill is the core equipment of the rolling technology.

轧环机是轧制技术的核心设备.

The complicated radial-axial ring rolling technology is used mainly to manufacture large rings, in which the radial and axial section of rings are rolled at the same time.

环件径轴向轧制是对环件径向和轴向同时进行轧制的复杂工艺，主要用于轧制大型环件。

This paper expounded and studied the curvilinear motion of a round ring by 3& dimension vector method systematically. The motion equations of curvilinear rolling were presented.

本文对圆环的曲线滚动以三维矢量法进行了阐述与研究，并导出其曲线滚动运动方程。

The general rule of rolling of ring piece is described.

叙述了环件轧制变形的一般规律.

Temperature variation is an important factor affecting ring rolling process.

温度变化是影响环件轧制过程的重要因素.

It confirms that tempering quality after being circle checked is the main cause for deformation of the steam seal ring made by rolling.

通过分析，确认校圆后的回火质量是钢板卷制汽封圈产生变形的主要原因。

This article is the investigation to the students of Binzhou university in thumb, ring finger food type, Wen-penetration, rolling and the earlobe.

文章对滨州学院在校学生的拇指类型、食环指类型、通贯纹、卷舌、耳垂五对性状进行了抽样调查，研究分析其遗传方式。

This paper mainly illustrates the full tracing test for steam seal ring made by rolling while being manufactured by X-ray.

钢板卷制汽封圈在切割成弧段时发生不同程度的收缩变形。采用X射线法对汽封圈的制造过程进行了跟踪测试。

it researched bite condition and the relationship between friction and bite condition in cold ring rolling.

研究了环件冷辗扩的咬入条件,得到了摩擦与咬入条件之间的关系.

Theoretical Design of Working Parameters of Ring Rolling Mill

轧环机工作参数理论设计